11/30212232 DC : DRAFT AUG 2011

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

BS ISO 13383-1 - FINE CERAMICS (ADVANCED CERAMICS, ADVANCED TECHNICAL CERAMICS) - MICROSTRUCTURAL CHARACTERIZATION - PART 1: DETERMINATION OF GRAIN SIZE AND SIZE DISTRIBUTION

Available format(s):

Superseded date: 30-09-2012

Language(s):

Published date: 23-11-2012

Publisher: British Standards Institution

Table of Contents - (Show below) - (Hide below)

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Significance and use
5 Apparatus
6 Test piece preparation
7 Photomicrography
8 Measurement of micrographs
9 Calculation of results
10 Interferences and uncertainties
11 Test report
Annex A (informative) - Grinding and polishing
        procedures
Annex B (informative) - Etching procedures
Annex C (informative) - Setting Kohler illumination
        in an optical microscope
Annex D (informative) - Round-robin verification of
        Method A1
Annex E (informative) - Round-robin verification of
        Method B
Annex F (informative) - Grain size distribution
        measurement
Annex G (informative) - Results sheet - Grain size in
        accordance with ISO 13383-1
Bibliography

Abstract - (Show below) - (Hide below)

BS ISO 13383-1

General Product Information - (Show below) - (Hide below)

Comment Closes On
Committee	RPI/13
Document Type	Draft
ISBN
Pages
Published
Publisher	British Standards Institution
Status	Superseded
Superseded By	BS ISO 13383-1 : 2012 BS EN ISO 13383-1:2016

Standards Referencing This Book - (Show below) - (Hide below)

ISO/IEC 17025:2005	General requirements for the competence of testing and calibration laboratories
ISO 8468:2007	Ships and marine technology — Ship's bridge layout and associated equipment — Requirements and guidelines
ISO 6106:2013	Abrasive products — Checking the grain size of superabrasives
ISO 8486-1:1996	Bonded abrasives Determination and designation of grain size distribution Part 1: Macrogrits F4 to F220
EN 1006:2009	Advanced technical ceramics - Monolithic ceramics - Guidance on the selection of test pieces for the evaluation of properties
ISO 8486-2:2007	Bonded abrasives Determination and designation of grain size distribution Part 2: Microgrits F230 to F2000
ASTM E 930 : 1999	Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart