BS EN ISO 22476-7:2012

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Equipment
5 Test procedure
6 Test results
7 Reporting
Annex A (normative) - Dimensions of borehole jacks
        and related device factors
Annex B (normative) - Calibration and correction
Annex C (normative) - Field report example
Annex D (informative) - Test example
Annex E (normative) - Placing the borehole jack in
        the ground
Annex F (normative) - Resolutions and uncertainties
Bibliography

Describes the equipment requirements, execution of and reporting on borehole jack tests.

This part of ISO22476 specifies the equipment requirements, execution of and reporting on borehole jack tests.

NOTE This part of ISO22476 fulfils the requirements for borehole jack tests as part of geotechnical investigation and testing according to EN1997-1^[1] and EN1997-2.^[2]

This part of ISO22476 specifies the procedure for conducting a borehole jack test in ground stiff enough not to be adversely affected by the drilling operation. Two diametral cylindrical steel loading plates are placed in the ground and opened by pressure. Pressure applied to, and associated opening of the probe are measured and recorded so as to obtain a stress-displacement relationship of the ground for the range of the expected design stress.

This part of ISO22476 applies to test depths of ≤100 m and to testing either on land or off-shore.