PD IEC/TS 63066:2017

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Standard ratings
6 Classification of accessories
7 Marking
8 Dimensions
9 Protection against electric shock
10 Provision for earthing
11 Terminals and terminations
12 Interlocks
13 Resistance to ageing of rubber and thermoplastic
   material
14 General construction
15 Construction of accessories
16 Degrees of protection
17 Insulation resistance and dielectric strength
18 Mechanical endurance
19 Temperature rise
20 Mechanical strength
21 Screws, current-carrying parts and connections
22 Creepage distances, clearances and distances
   through sealing compound
23 Resistance to heat, to fire and to tracking
24 Conditional short-circuit current withstand test
25 Electromagnetic compatibility
26 Dynamic mechanical severities
27 Electrical endurance
28 Climatic endurance for contacts
29 Climatic endurance for bodies
30 Salt stress endurance
31 Operation with misalignments
32 Environmental conditions
Annex A (normative) - Test cycle electric endurance
Annex B (informative) - Environmental performance
        classes for vehicles
Annex C (informative) - Examples for accessories on
        the market
Bibliography

Pertains to docking connectors (hereinafter referred to as accessories) incorporated in or fixed to electrical equipment, intended to connect removable energy storage units to a dedicated electric power conversion unit, to an energy consuming unit or to another energy storage unit.

This document applies to docking connectors (hereinafter referred to as accessories) incorporated in or fixed to electrical equipment, intended to connect removable energy storage units to a dedicated electric power conversion unit, to an energy consuming unit or to another energy storage unit.

These accessories are intended for DC and may include an earth¹ contact and/or optional auxiliary contacts for signaling and data. These accessories have a rated current of up to 800 A and rated operating voltages not exceeding 1 000 V DC.

These accessories are not suiTable for mating or unmating under load. These accessories are intended to be installed by instructed persons ( IEC 60050-195:1998 , 195-04-02) or skilled persons ( IEC 60050-195:1998 , 195-04-01) only.

The list of preferred ratings is not intended to exclude other ratings.

This document applies to accessories for use under environmental conditions as described in Clause 32.

These accessories are intended to be connected to current carrying parts in copper or copper alloy only, plated or not plated.

This document also applies to accessories intended to be used at extra-low voltage.

In locations where special conditions prevail, for example on board vehicles, additional requirements may apply.

These accessories are intended to be used with a specific charging system.

NOTE For conditions other than operation, additional requirements could be applicable, for instance IEC 62133 and the UN Recommendations on the Transport of Dangerous Goods section 38.338.3.