Skip to content
Please enter a keyword to search
  • Preview

    I.S. EN 22768-2:1994

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    GENERAL TOLERANCES - GEOMETRICAL TOLERANCES FOR FEATURES WITHOUT INDIVIDUAL TOLERANCE INDICATIONS

    Available format(s):  Hardcopy, PDF

    Superseded date:  08-03-2021

    Language(s):  English

    Published date:  01-01-1994

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    Introduction
    1 Scope
    2 General
    3 Normative references
    4 Definitions
    5 General geometrical tolerances
    6 Indications on drawings
    7 Rejection
    Annex A (informative) Concepts behind general
            tolerancing of geometrical characteristics
    Annex B (informative) Further information

    Abstract - (Show below) - (Hide below)

    Simplifies drawing indications and specifies general geometrical tolerances to control those features on the drawing which have no respective individual indication.

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO 8015:2011 Geometrical product specifications (GPS) Fundamentals Concepts, principles and rules
    ISO 5459:2011 Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems
    ISO 1101:2017 Geometrical product specifications (GPS) — Geometrical tolerancing — Tolerances of form, orientation, location and run-out
    ISO 2768:1973 Permissible machining variations in dimensions without tolerance indication
    EN 22768-1:1993 General tolerances - Part 1: Tolerances for linear and angular dimensions without individual tolerance indications (ISO 2768-1:1989)
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective