NF EN 62149-5 : 2011

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

FIBER OPTIC ACTIVE COMPONENTS AND DEVICES - PERFORMANCE STANDARDS - PART 5: ATM-PON TRANSCEIVERS WITH LD DRIVER AND CDR ICS

Available format(s):

Superseded date: 09-11-2021

Language(s):

Published date: 12-01-2013

Publisher: Association Francaise de Normalisation

Table of Contents - (Show below) - (Hide below)

AVANT-PROPOS
INTRODUCTION
1 Domaine d'application
2 Références normatives
3 Termes, définitions et abréviations
  3.1 Termes et définitions
  3.2 Abréviations
4 Classification
5 Définition de produit
  5.1 Description du module d'émetteur-récepteur
  5.2 Description de forme appliquée
  5.3 Schéma fonctionnel
  5.4 Valeurs limites absolues
  5.5 Spécification fonctionnelle
6 Essais
  6.1 Essais de caractérisation
  6.2 Essais de performance
7 Spécifications d'environnement
  7.1 Sécurité générale
  7.2 Sécurité du laser
  7.3 Emission électromagnétique
Annexe A (normative) Mesure sur la tolérance au flux
                      énergétique réfléchi (Tableau 3,
                      Paramètre 13)
Annexe B (normative) Niveau logique du signal d'alarme et
                      du signal d'arrêt
Annexe ZA (normative) Références normatives à d'autres
                      publications internationales avec les
                      publications européennes correspondantes

Abstract - (Show below) - (Hide below)

Specifies standards on the transceiver modules for asynchronous-transfer-mode passive optical network (ATM-PON) systems recommended by the International Telecommunication Union (ITU) in Recommendation TG.983.1.

General Product Information - (Show below) - (Hide below)

Development Note	Indice de classement: C93-884-5. PR NF EN 62149-5 September 2002. (10/2002) PR NF EN 62149-5 May 2008. (05/2008)
Document Type	Standard
ISBN
Pages
Published
Publisher	Association Francaise de Normalisation
Status	Superseded
Superseded By	NF EN IEC 62149-5:2020

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
EN 62149-5:2011	Identical
NBN EN 62149-5 : 2011	Identical
SN EN 62149-5 : 2003	Identical
DIN EN 62149-5 : 2011	Identical
I.S. EN 62149-5:2011	Identical
IEC 62149-5:2009	Identical
BS EN 62149-5:2011	Identical

Standards Referencing This Book - (Show below) - (Hide below)

IEC 60950-1:2005+AMD1:2009+AMD2:2013 CSV	Information technology equipment - Safety - Part 1: General requirements
IEC 60068-2-27:2008	Environmental testing - Part 2-27: Tests - Test Ea and guidance: Shock
IEC 60825-1:2014	Safety of laser products - Part 1: Equipment classification and requirements
IEC 61300-2-17:2010	Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-17: Tests - Cold
IEC 61753-1:2007	Fibre optic interconnecting devices and passive components performance standard - Part 1: General and guidance for performance standards
IEC 61280-1-1:2013	Fibre optic communication subsystem basic test procedures - Part 1-1: Test procedures for general communication subsystems - Transmitter output optical power measurement for single-mode optical fibre cable
IEC 61300-2-18:2005	Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-18: Tests - Dry heat - High temperature endurance
IEC 61300-2-22:2007	Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-22: Tests - Change of temperature
IEC TR 61931:1998	Fibre optic - Terminology
IEC 61300-3-6:2008	Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-6: Examinations and measurements - Return loss
IEC 61280-2-2:2012	Fibre optic communication subsystem test procedures - Part 2-2: Digital systems - Optical eye pattern, waveform and extinction ratio measurement
IEC 61300-2-4:1995	Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-4: Tests - Fibre/cable retention
IEC 61300-2-19:2012	Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-19: Tests - Damp heat (steady state)
IEC 62150-2:2010	Fibre optic active components and devices - Test and measurement procedures - Part 2: ATM-PON transceivers

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart