0 Introduction
1 Scope
2 References
3 Definitions
4 Health and safety
5 Principle
6 Testing requirements
7 Test report
Annex A (normative) Types of test piece to be used for sheet
and strip with thickness less than 8 mm
Annex B (normative) Types of non-machined test piece to be
used in the case of bar, section and wire
with a diameter or thickness less than or
equal to 8 mm
Annex C (normative) Types of machined test piece to be used
in the case of bar, section, plate and
wire with diameter or thickness greater
than 8 mm and for forgings and castings
Annex D (normative) Types of test piece to be used in the case
of tubes