BS EN 62035:2014

1 Scope
2 Normative references
3 Terms and definitions
4 General safety requirements
5 Particular safety requirements
6 Information for luminaire design
7 Assessment
Annex A (normative) - List of lamp caps and gauges
Annex B (normative) - Pull and torsion test values
Annex C (normative) - Torsion test holders
Annex D (normative) - Information for thermal tests
Annex E (normative) - Measurement of pulse height for lamps
        with internal starting device
Annex F (informative) - Information for luminaire design
Annex G (normative) - Conditions of compliance for design
        tests
Annex H (normative) - Symbols
Annex I (normative) - Containment testing procedure
        for metal halide lamps with quartz arc tubes
Annex J (normative) - Containment testing procedure for
        metal halide lamps with ceramic arc tubes
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European
         publications

Describes the safety requirements for discharge lamps (excluding fluorescent lamps) for general lighting purposes.

This International Standard specifies the safety requirements for discharge lamps (excluding fluorescent lamps) for general lighting purposes. This International Standard is applicable to low-pressure sodium vapour lamps and to high-intensity discharge (HID) lamps, i.e. high-pressure mercury vapour lamps (including This standard only concerns safety criteria and does not take into account performance. The performance standards IEC60188 , IEC60192 , IEC60662 , IEC61167 and IEC61549 should be referred to for such characteristics. It may be expected that lamps which comply with this standard will operate safely at supply voltages between 90% and 110% of rated supply voltage and when operated with a ballast complying with IEC61347‑2‑9 and IEC60923 , with a starting device complying with IEC61347‑2‑1 and IEC60927 , and in a luminaire complying with IEC60598‑1 .