BS ISO 13106:2014

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Raw material
5 Container capacity
6 Container mass
7 Tolerance on dimensions
8 Performance requirements
9 Statutory marking
10 Sampling and criterion for conformity
Annex A (normative) - Container and neck
        finish descriptions
Annex B (normative) - Determination of brimful
        capacity
Annex C (normative) - Measurement of container
        wall thickness
Annex D (normative) - Measurement of container
        overall height
Annex E (normative) - Measurement of diameter
        for round container
Annex F (normative) - Measurement of neck height
Annex G (normative) - Measurement of neck and
        thread diameters and neck ovality
Annex H (normative) - Drop impact resistance test
Annex I (normative) - Stack load test
Annex J (normative) - Leakage test
Annex K (normative) - Ink adhesion test for
        printed containers

Specifies the requirements for polypropylene resins intended for use in blow-moulded, round containers with capacities up to, and including two litres intended for the packaging of liquids for human consumption.

This International Standard provides the requirements of polypropylene resins intended for use in blow-moulded, round containers with capacities up to, and including two litres intended for the packaging of liquids for human consumption. This International Standard also provides tolerances on mass, dimensions, methods of sampling, testing, and performance requirements.

NOTE It is not to be implied that polypropylene resins are the only polymers suitable for these applications, as many other polymers, including PE-HD, PET, etc. are also suitable.