• ANSI C63.10 : 2013

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    PROCEDURES FOR COMPLIANCE TESTING OF UNLICENSED WIRELESS DEVICES

    Available format(s):  Hardcopy, PDF

    Superseded date:  07-04-2021

    Language(s):  English

    Published date:  13-09-2013

    Publisher:  Institute of Electrical & Electronics Engineers

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    1. Overview
    2. Normative references
    3. Definitions and acronyms
    4. Measurement instrumentation
    5. General measurement and setup considerations
    6. Standard test methods
    7. Additional tests and requirements for specific
        devices
    8. Procedure for determining emissions from FM
        transmitters designed for use in vehicles
    9. Procedures for testing millimeter-wave systems
    10. Procedures for measuring ultra-wideband devices
    11. Procedures for testing DTS devices
    12. Testing of Unlicensed National Information
        Infrastructure (U-NII) devices
    13. Procedures for measuring device operating using
        antenna arrays with beam-steering and/or
        beamforming capability
    14. Procedures for combining emissions and computing
        directional gain from devices with multiple outputs
    15. Test reports
    Annex A (informative) - Cross-references between
            regulatory requirements and ANSI C63.10
            test methods
    Annex B (informative) - Example test report contents
    Annex C (informative) - Pulse desensitization
            considerations for emission measurements using
            a spectrum analyzer or EMI receiver
            (Schaefer [B52])
    Annex D (informative) - Detector functions
    Annex E (informative) - Measurements above 1 GHz -
            instrumentation perspective
    Annex F (informative) - Broadband measurement discussion
    Annex G (informative) - Basic relationships among field
            strength, power, effective radiated power, and
            equivalent isotropically radiated power
    Annex H (informative) - Rationale for making radiated
            emission measurements using two different
            methods
    Annex I (informative) - Site considerations for measuring
            inductive-loop devices in the near field
    Annex J (informative) - Developing a transfer function
            for FM transmitters (alternative procedure for
            determining compliance of unlicensed FM
            transmitters)
    Annex K (informative) - Glossary
    Annex L (informative) - Bibliography

    Abstract - (Show below) - (Hide below)

    Defines U.S. consensus standard methods and instrumentation and test facilities requirements for measurement of radio frequency (RF) signals and noise emitted from unlicensed wireless devices operating in the frequency range 9 kHz to 231 GHz.

    General Product Information - (Show below) - (Hide below)

    Committee C 63
    Document Type Standard
    Publisher Institute of Electrical & Electronics Engineers
    Status Superseded
    Superseded By
    Supersedes

    Standards Referenced By This Book - (Show below) - (Hide below)

    IEEE C63.7 : 2015 GUIDE FOR CONSTRUCTION OF TEST SITES FOR PERFORMING RADIATED EMISSION MEASUREMENTS
    ANSI C63.4 : 2014 METHODS OF MEASUREMENT OF RADIO-NOISE EMISSIONS FROM LOW-VOLTAGE ELECTRICAL AND ELECTRONIC EQUIPMENT IN THE RANGE OF 9 KHz TO 40 GHz
    ANSI C63.14 : 2014 DICTIONARY OF ELECTROMAGNETIC COMPATIBILITY (EMC) INCLUDING ELECTROMAGNETIC ENVIRONMENTAL EFFECTS (E3)
    ANSI C63.15 : 2010 RECOMMENDED PRACTICE FOR THE IMMUNITY MEASUREMENT OF ELECTRICAL AND ELECTRONIC EQUIPMENT
    ANSI C63.2 : 2009 SPECIFICATIONS OF ELECTROMAGNETIC INTERFERENCE AND FIELD STRENGTH MEASURING INSTRUMENTATION IN THE FREQUENCY RANGE 9 KHZ TO 40 GHZ
    IEEE/ANSI C63.5-2017 ELECTROMAGNETIC COMPATIBILITY - RADIATED EMISSION MEASUREMENTS IN ELECTROMAGNETIC INTERFERENCE (EMI) CONTROL - CALIBRATION AND QUALIFICATION OF ANTENNAS (9 KHZ TO 40 GHZ)
    ANSI C63.26 : 2015 COMPLIANCE TESTING OF TRANSMITTERS USED IN LICENSED RADIO SERVICES

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories
    CISPR 16-4-2:2011+AMD1:2014 CSV Specification for radio disturbance and immunity measuring apparatusand methods - Part 4-2: Uncertainties, statistics and limit modelling - Measurement instrumentation uncertainty
    CISPR 16-1-4:2010+AMD1:2012+AMD2:2017 CSV Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-4: Radio disturbance and immunity measuring apparatus - Antennas and test sites for radiated disturbance measurements
    CISPR 16-1-1:2015 Specification for radio disturbance and immunity measuring apparatus and methods - Part 1-1: Radio disturbance and immunity measuring apparatus - Measuring apparatus
    TR 102 070-1 : 1.2.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); GUIDE TO THE APPLICATION OF HARMONIZED STANDARDS TO MULTI-RADIO AND COMBINED RADIO AND NON-RADIO EQUIPMENT; PART 1: ELECTROMAGNETIC COMPATIBILITY
    EN 300 440-1 : 1.6.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); SHORT RANGE DEVICES; RADIO EQUIPMENT TO BE USED IN THE 1 GHZ TO 40 GHZ FREQUENCY RANGE; PART 1: TECHNICAL CHARACTERISTICS AND TEST METHODS
    CISPR 16-2-1:2014 Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-1: Methods of measurement of disturbances and immunity - Conducted disturbance measurements
    IEEE 1309 : 2013 CALIBRATION OF ELECTROMAGNETIC FIELD SENSORS AND PROBES (EXCLUDING ANTENNAS) FROM 9 KHZ TO 40 GHZ
    ANSI C63.4 : 2014 METHODS OF MEASUREMENT OF RADIO-NOISE EMISSIONS FROM LOW-VOLTAGE ELECTRICAL AND ELECTRONIC EQUIPMENT IN THE RANGE OF 9 KHz TO 40 GHz
    ATIS T1.523 : 2001
    TR 100 028-1 : 1.4.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); UNCERTAINTIES IN THE MEASUREMENT OF MOBILE RADIO EQUIPMENT CHARACTERISTICS PART 1
    IEEE 802.11 : 2016 INFORMATION TECHNOLOGY - TELECOMMUNICATIONS AND INFORMATION EXCHANGE BETWEEN SYSTEMS LOCAL AND METROPOLITAN AREA NETWORKS - SPECIFIC REQUIREMENTS
    EN 300 330-2 : 1.6.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); SHORT RANGE DEVICES (SRD); RADIO EQUIPMENT IN THE FREQUENCY RANGE 9 KHZ TO 25 MHZ AND INDUCTIVE LOOP SYSTEMS IN THE FREQUENCY RANGE 9 KHZ TO 30 MHZ; PART 2: HARMONIZED EN COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE R&TTE DIRECTIVE
    CFR 47(PTS0-19) : OCT 2017 TELECOMMUNICATION - FEDERAL COMMUNICATIONS COMMISSION
    IEEE 1560 : 2005 METHODS OF MEASUREMENT OF RADIO-FREQUENCY POWER-LINE INTERFERENCE FILTER IN THE RANGE OF 100 HZ TO 10 GHZ
    IEEE 1528 : 2013 RECOMMENDED PRACTICE FOR DETERMINING THE PEAK SPATIAL-AVERAGE SPECIFIC ABSORPTION RATE (SAR) IN THE HUMAN HEAD FROM WIRELESS COMMUNICATIONS DEVICES: MEASUREMENT TECHNIQUES
    ANSI C63.14 : 2014 DICTIONARY OF ELECTROMAGNETIC COMPATIBILITY (EMC) INCLUDING ELECTROMAGNETIC ENVIRONMENTAL EFFECTS (E3)
    EN 302 245-1 : 1.1.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); TRANSMITTING EQUIPMENT FOR THE DIGITAL RADIO MONDIALE (DRM) BROADCASTING SERVICE; PART 1: TECHNICAL CHARACTERISTICS AND TEST METHODS
    TR 102 324 : 1.1.1 POWERLINE TELECOMMUNICATIONS (PLT); RADIATED EMISSIONS' CHARACTERISTICS AND MEASUREMENT METHOD OF STATE OF THE ART POWERLINE COMMUNICATION NETWORKS
    IEEE 686-2008 RADAR DEFINITIONS
    ANSI C63.2 : 2009 SPECIFICATIONS OF ELECTROMAGNETIC INTERFERENCE AND FIELD STRENGTH MEASURING INSTRUMENTATION IN THE FREQUENCY RANGE 9 KHZ TO 40 GHZ
    CISPR 16-2-3:2016 Specification for radio disturbance and immunity measuring apparatus and methods - Part 2-3: Methods of measurement of disturbances and immunity - Radiated disturbance measurements
    ANSI C63.5 : 2006 ELECTROMAGNETIC COMPATIBILITY - RADIATED EMISSION MEASUREMENTS IN ELECTROMAGNETIC INTERFERENCE (EMI) CONTROL - CALIBRATION AND QUALIFICATION OF ANTENNAS (9 KHZ TO 40 GHZ)
    IEEE 802.16-2012 Standard for Air Interface for Broadband Wireless Access Systems
    CFR 47(PTS20-39) : OCT 2017 TELECOMMUNICATIONS - FEDERAL COMMUNICATIONS COMMISSION
    ISO 10012-1:1992 Quality assurance requirements for measuring equipment Part 1: Metrological confirmation system for measuring equipment
    CFR 47(PTS80-END) : OCT 2017 TELECOMMUNICATION - FEDERAL COMMUNICATIONS COMMISSION
    ANSI C63.17:2013
    TR 100 028-2 : 1.4.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); UNCERTAINTIES IN THE MEASUREMENT OF MOBILE RADIO EQUIPMENT CHARACTERISTICS PART 2
    IEEE C63.7 : 2015 GUIDE FOR CONSTRUCTION OF TEST SITES FOR PERFORMING RADIATED EMISSION MEASUREMENTS
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective