• BS 7822-3:1995

    Current The latest, up-to-date edition.

    INSULATION COORDINATION FOR EQUIPMENT WITHIN LOW-VOLTAGE SYSTEMS - USE OF COATINGS TO ACHIEVE INSULATION COORDINATION OF PRINTED BOARD ASSEMBLIES

    Available format(s):  Hardcopy, PDF

    Language(s):  English

    Published date:  01-01-1995

    Publisher:  British Standards Institution

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Committees responsible
    National foreword
    Introduction
    SPECIFICATION
    1 Scope
    2 Normative references
    3 Definitions
    4 Design requirements
    5 Test specimens
    6 Tests
    Annexes
    A (normative) Test sequence for type A coating
    B (normative) Test sequence for type B coating
    C (informative) Measuring the insulation distance of a
       coated printed board
    Table
    1 Degrees of severities for rapid change of
       temperature
    Figures
    1 Test specimen
    2 Examples of land configurations
    C.1 Measurement of the insulation distance

    Abstract - (Show below) - (Hide below)

    Applies to rigid printed board assemblies with an insulating coating applied to one or both sides of the printed board. Describes the requirements and test procedures for printed board assemblies provided with coatings.

    General Product Information - (Show below) - (Hide below)

    Committee GEL/28
    Development Note Supersedes 88/22388 DC (10/2005)
    Document Type Standard
    Publisher British Standards Institution
    Status Current

    Standards Referencing This Book - (Show below) - (Hide below)

    BS 5901:1980 METHOD OF TEST FOR DETERMINING THE COMPARATIVE AND THE PROOF TRACKING INDICES OF SOLID INSULATING MATERIALS UNDER MOIST CONDITIONS
    BS 4584-103.3:1992 METAL-CLAD BASE MATERIALS FOR PRINTED WIRING BOARDS - SPECIAL MATERIALS USED IN CONNECTION WITH PRINTED CIRCUITS - SPECIFICATION FOR PERMANENT POLYMER COATING MATERIALS (SOLDER RESIST) FOR USE IN THE FABRICATION OF PRINTED BOARDS
    BS 2011-2.1N:1985 ENVIRONMENTAL TESTING - TESTS - TEST N: CHANGE OF TEMPERATURE
    BS 2011-2.1Ca:1977 ENVIRONMENTAL TESTING - TESTS - TEST CA - DAMP HEAT, STEADY STATE
    BS 6221-2:1991 PRINTED WIRING BOARDS - METHODS OF TEST
    IEC 60068-2-2:2007 Environmental testing - Part 2-2: Tests - Test B: Dry heat
    BS 4727-1:GRP11(1991) : 1991 GLOSSARY OF ELECTROTECHNICAL, POWER, TELECOMMUNICATION, ELECTRONICS, LIGHTING AND COLOUR TERMS - TERMS COMMON TO POWER, TELECOMMUNICATIONS AND ELECTRONICS - PRINTED CIRCUITS
    IEC 60364-4-443:1995+AMD1:1998 CSV Electrical installations of buildings - Part 4: Protection for safety - Chapter 44: Protection against overvoltages - Section 443: Protection against overvoltages of atmospheric origin or due to switching
    IEC 60068-2-1:2007 Environmental testing - Part 2-1: Tests - Test A: Cold
    IEC 60664-1:2007 Insulation coordination for equipment within low-voltage systems - Part 1: Principles, requirements and tests
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective