CAN/CSA-C22.2 NO. 60745-2-5-12 (R2016)

Preface
NATIONAL DIFFERENCES
FOREWORD
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 General conditions for the tests
6 Void
7 Classification
8 Marking and instructions
9 Protection against access to live parts
10 Starting
11 Input and current
12 Heating
13 Leakage current
14 Moisture resistance
15 Electric strength
16 Overload protection of transformers and
   associated circuits
17 Endurance
18 Abnormal operation
19 Mechanical hazards
20 Mechanical strength
21 Construction
22 Internal wiring
23 Components
24 Supply connection and external flexible cords
25 Terminals for external conductors
26 Provision for earthing
27 Screws and connections
28 Creepage distances, clearances and distances
   through insulation
29 Resistance to heat, fire and tracking
30 Resistance to rusting
31 Radiation, toxicity and similar hazards
Annexes
Annex K (normative) - Battery tools and battery packs
Annex L (normative) - Battery tools and battery packs
        provided with mains connection or non-isolated
        sources
Annex M (normative) - Safety of working stands for
        operation with hand-held motor-operated
        electric tools
Annex AA (normative) - Additional requirements for
         saws with a riving knife
Annex BB (normative) - Additional requirements for
         lower guards for saws without a riving knife
Bibliography

This Standard applies to circular saws, which hereinafter will be referred to as saws.

Preface This is the harmonized CSA and UL standard for Hand-Held Motor-Operated Electric Tools - Safety - Part 2-5: Particular Requirements for Circular Saws. It is the fourth edition of CAN/CSA-C22.2 No.60745-2-5 and the fifth edition of UL 60745-2-5. This Standard is based on IEC 60745-2-5, fifth edition. Scope This clause of part 1 is applicable, except as follows: Addition: This Standard applies to circular saws, which hereinafter will be referred to as saws. This Standard does not apply to saws designed for use with abrasive wheels. NOTE Saws designed for use with abrasive wheels as cut-off machines are covered by IEC 60745-2-22.