CSA CEI/IEC 61000.4.6 : 0

FOREWORD
INTRODUCTION
1. Scope
2. Normative references
3. General
4. Definitions
5. Test levels
6. Test equipment
   6.1 Test generator
   6.2 Coupling and decoupling devices
   6.3 Verification of the common-mode impedance at the
       EUT port of coupling and decoupling devices
   6.4 Setting of the test generator
7. Test set-up for table-top and floor-standing equipment
   7.1 Rules for selecting injection methods and test points
   7.2 Procedure for clamp injection application
   7.3 Procedure for clamp injection when the common-mode
       impedance requirements cannot be met
   7.4 EUT comprising a single unit
   7.5 EUT comprising several units
8. Test procedure
9. Test results and test report
Annexes
A Additional information regarding clamp injection
B Selection criteria for the frequency range of application
C Guide for selecting test levels
D Information on coupling and decoupling networks
E Information for the test generator specification

Connects to the conducted immunity requirements of electrical and electronic equipment to electromagnetic disturbances coming from intended radio-frequency (RF) transmitters in the frequency range 9 kHZ up to 80 MHz. Equipment not having at least one conducting cable (such as mains supply, signal line or earth connection), which can couple the equipment to the disturbing RF fields is excluded.