EIA 481-1 : A1994

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

8 MM AND 12 MM TAPING OF SURFACE MOUNT COMPONENTS FOR AUTOMATIC HANDLING

Available format(s):

Superseded date: 23-07-2013

Language(s):

Published date: 12-01-2013

Publisher: JEDEC Solid State Technology Association

Table of Contents - (Show below) - (Hide below)

1. Scope
2. Introduction
3. Applicable Documents
4. Requirements
Figures
1. 8mm & 12mm Punched Carrier Tape Configuration
2. 8mm & 12mm Embossed Carrier Tape Configuration
3. Tape Leader and Trailer Dimensions
4. Reel Configuration
5. Electrical Polarization, 2-Termination Devices
6. Mechanical Polarization, SOT-23 Devices
7. Mechanical Polarization, SOT-143 Devices
8. Mechanical Polarization, SOT-89 Devices
9. Mechanical Polarization, SOT-223 Devices
10. Mechanical Polarization, SO-IC Devices
Tables
1. 8mm & 12mm Punched Carrier Tape Dimensions
2. 8mm & 12mm Embossed Carrier Tape Dimensions
3. Reel Dimensions

Abstract - (Show below) - (Hide below)

Provides dimensions and tolerances necessary to tape surface mounted components such that they be automatically handled. Covers taping requirements for active and passive surface mounted components such as but not limited to diodes, capacitors, resistors, transistors, inductors and integrated circuits. It defines only 8mm and 12mm carrier tapes for surface mount components.

General Product Information - (Show below) - (Hide below)

Committee	ACH
Document Type	Standard
ISBN
Pages
Published
Publisher	JEDEC Solid State Technology Association
Status	Superseded
Superseded By	EIA 481 : E2015

Standards Referenced By This Book - (Show below) - (Hide below)

I.S. EN 61188-5-2:2003	PRINTED BOARDS AND PRINTED BOARD ASSEMBLIES - DESIGN AND USE - PART 5-2: ATTACHMENT (LAND/JOINT) CONSIDERATIONS - DISCRETE COMPONENTS
95/208506 DC : 0	IEC 61188-5-2 - DESIGN AND USE OF PRINTED BOARDS AND PRINTED BOARD ASSEMBLIES - PART 5: SECTIONAL DESIGN AND USE REQUIREMENTS - ATTACHMENT (LAND/JOINT) CONSIDERATIONS - SECTION 2: DISCRETE COMPONENTS
BS EN 61188-5-2 : 2003	PRINTED BOARDS AND ASSEMBLIES - DESIGN AND USE - PART 5-2: ATTACHMENT (LAND/JOINT) CONSIDERATIONS - DISCRETE COMPONENTS
IEC 61188-5-2:2003	Printed boards and printed board assemblies - Design and use - Part 5-2: Attachment (land/joint) considerations - Discrete components
EN 61188-5-2 : 2003	PRINTED BOARDS AND PRINTED BOARD ASSEMBLIES - DESIGN AND USE - PART 5-2: ATTACHMENT (LAND/JOINT) CONSIDERATIONS - DISCRETE COMPONENTS

Cross Sell - (Show below) - (Hide below)

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart