EN 1652:1997/AC:2003

Foreword
1 Scope
2 Normative references
3 Definitions
   3.1 plate
   3.2 sheet
   3.3 strip
   3.4 circle
4 Designations
   4.1 Material
   4.2 Material condition
   4.3 Product
5 Ordering information
6 Requirements
   6.1 Composition
   6.2 Mechanical properties
   6.3 Grain size
   6.4 Dimensions and tolerances
   6.5 Edgewise curvature c
   6.6 Surface condition
7 Sampling
   7.1 General
   7.2 Analysis
   7.3 Tensile, hardness, grain size and technological
       tests
8 Test methods
   8.1 Analysis
   8.2 Tensile test
   8.3 Hardness test
   8.4 Estimation of average grain size
   8.5 Technological tests
   8.6 Retests
   8.7 Rounding of results
9 Declaration of conformity and inspection of documentation
   9.1 Declaration of conformity
   9.2 Inspection of documentation
10 Marking, packaging, labelling
Table 1 Composition of copper
Table 2 Composition of copper alloys
Table 3 Mechanical properties
Table 4 Tolerances on thickness of hot rolled products
         (plate, sheet, strip and circles)
Table 5 Tolerances on thickness of cold rolled products
         (sheet, strip and circles)
Table 6 Tolerances on width of cold rolled strip
Table 7 Tolerances on width of plate and sheet
Table 8 Tolerances on length of plate, sheet and strip
         cut to length for lengths up to 5000 mm
Table 9 Squareness of cut plate and sheet
Table 10 Tolerances on diameter for circles
Table 11 Edgewise curvature
Annex A (informative) Bibliography

Defines the composition, property requirements and tolerances on dimensions and form for copper and copper alloy plate, sheet, strip and circles for general use.