Skip to content
Please enter a keyword to search

  • IEC 60099-6:2002

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    Surge arresters - Part 6: Surge arresters containing both series and parallel gapped structures - Rated 52 kV and less

    Available format(s):  Hardcopy, PDF, PDF 3 Users, PDF 5 Users, PDF 9 Users

    Superseded date:  31-12-2021

    Language(s):  English

    Published date:  14-08-2002

    Publisher:  International Electrotechnical Committee

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 General
       1.1 Scope
       1.2 Normative references
    2 Definitions
    3 Identification and classification
       3.1 Arrester identification
       3.2 Arrester classification
    4 Standard ratings
       4.1 Standard rated voltages
       4.2 Standard rated frequencies
       4.3 Standard nominal discharge currents
       4.4 Service conditions
    5 Requirements
       5.1 Insulation withstand of the arrester housing
       5.2 Reference voltage
       5.3 Impulse protective levels
       5.4 Partial discharges
       5.5 Seal leakage
       5.6 Thermal stability
       5.7 Long duration current impulse withstand
       5.8 Operating duty
       5.9 Power frequency voltage versus time characteristics
            of an arrester
       5.10 Short-circuit withstand
       5.11 Disconnectors
       5.12 Requirements for internal and external grading
            components
       5.13 Power frequency sparkover
       5.14 Grading current
       5.15 Weather ageing tests
    6 General procedures
       6.1 Measuring equipment and accuracy
       6.2 Reference voltage measurements
       6.3 Test samples
    7 Type tests (design tests)
       7.1 General
       7.2 Insulation withstand tests on the arrester housing
       7.3 Impulse protective level tests
       7.4 Long duration current impulse withstand test
       7.5 Operating duty tests
       7.6 Tests of arrester disconnectors
       7.7 Power frequency voltage sparkover tests
       7.8 Moisture ingress tests
       7.9 Weather ageing tests
    8 Routine tests and acceptance tests
       8.1 Routine tests
       8.2 Acceptance tests
    Annex A (normative) Abnormal service conditions
    Annex B (normative) Test to verify thermal equivalency
            between complete arrester and arrester section
    Annex C (normative) Procedure to verify the power frequency
            voltage versus time characteristics of an arrester
    Annex D (normative) Artificial pollution testing of
            metal-oxide surge arresters containing gapped
            structures
    Annex E (informative) Typical information given with
            inquiries and tenders
    Annex F (informative) Typical maximum protective levels
    Bibliography
    Figures
    Tables

    Abstract - (Show below) - (Hide below)

    This standard basically applies to all metal-oxide surge arresters with gaps and housed in either porcelain or polymeric housings.This standard also specifies requirements and tests for metal-oxide surge arresters with internal series gaps,with rated voltages of 52KV and below.

    General Product Information - (Show below) - (Hide below)

    Committee TC 37
    Development Note Stability Date: 2017. (09/2017)
    Document Type Standard
    Publisher International Electrotechnical Committee
    Status Superseded
    Superseded By

    Standards Referenced By This Book - (Show below) - (Hide below)

    10/30210015 DC : 0 BS EN 60099-5 - SURGE ARRESTERS - SELECTION AND APPLICATION RECOMMENDATIONS
    17/30339060 DC : 0 BS EN 60071-2 - INSULATION CO-ORDINATION - PART 2: APPLICATION GUIDE (PROPOSED HORIZONTAL STANDARD)
    IEC 60099-5:2018 Surge arresters - Part 5: Selection and application recommendations
    IEC 60099-5:2018 RLV Surge arresters - Part 5: Selection and application recommendations
    CEI EN 60099-5 : 2014 SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS
    IEC 60071-2:2018 RLV Insulation co-ordination - Part 2: Application guidelines
    BS EN 60099-5:2013 Surge arresters Selection and application recommendations
    EN IEC 60071-2:2018 Insulation co-ordination - Part 2: Application guidelines
    I.S. EN IEC 60071-2:2018 INSULATION CO-ORDINATION - PART 2: APPLICATION GUIDELINES
    NF EN 60099-5 : 2017 SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS
    I.S. EN 60099-5:2013 SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS (IEC 60099-5:2013 (EQV))
    EN IEC 60099-5:2018 Surge arresters - Part 5: Selection and application recommendations
    IEC 60071-2 REDLINE : 4ED 2018 INSULATION CO-ORDINATION - PART 2: APPLICATION GUIDELINES
    16/30340451 DC : DRAFT APR 2016 BS EN 60099-5 - SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS
    IEC 60099-5 REDLINE : 3.0 SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS
    I.S. EN IEC 60099-5:2018 SURGE ARRESTERS - PART 5: SELECTION AND APPLICATION RECOMMENDATIONS
    IEC 60071-2:2018 Insulation co-ordination - Part 2: Application guidelines
    EN 60099-5:2013 Surge arresters - Part 5: Selection and application recommendations

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 60060-2:2010 High-voltage test techniques - Part 2: Measuring systems
    IEC 60270:2000+AMD1:2015 CSV High-voltage test techniques - Partial discharge measurements
    IEC 60099-4:2014 Surge arresters - Part 4: Metal-oxide surge arresters without gaps for a.c. systems
    IEC 60099-1:1991+AMD1:1999 CSV Surge arresters - Part 1: Non-linear resistor type gapped surge arresters for a.c. systems
    IEC 60099-5:2013 Surge arresters - Part 5: Selection and application recommendations
    IEC 60071-2:1996 Insulation co-ordination - Part 2: Application guide
    IEC 60060-1:2010 High-voltage test techniques - Part 1: General definitions and test requirements
    IEC 60071-1:2006+AMD1:2010 CSV Insulation co-ordination - Part 1: Definitions, principles and rules
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective