SN EN 60252 : 1994

Cooperating organizations
National foreword
Foreword
Section 1: General
1.1 Scope and object
1.2 Normative references
1.3 Definitions
1.4 Service conditions
1.5 Preferred tolerances on capacitance
Section 2: Quality requirements and tests
2.1 Test requirements
2.2 Nature of tests
2.3 Type tests
2.4 Routine tests
2.5 Tangent of loss angle
2.6 Visual examination
2.7 Voltage test between terminals
2.8 Voltage test between terminals and case
2.9 Capacitance measurement
2.10 Check of dimensions
2.11 Mechanical tests
2.12 Sealing test
2.13 Endurance test
2.14 Damp-heat test
2.15 Self-healing test
2.16 Destruction test
Section 3: Overloads
3.1 Permissible overloads
Section 4: Safety requirements
4.1 Creepage distances and clearances
4.2 Terminals and connecting cables
4.3 Earth connections
4.4 Discharge devices
Section 5: Ratings
5.1 Marking
Section 6: Guide for installation and operation
6.1 General
6.2 Choice of rated voltage
6.3 Checking capacitor temperature
6.4 Checking transients
6.5 Leakage current
Annex A - Test voltage
Annex ZA - (normative) Other international publications
quoted in this standard with the references of the
relevant European publications

Applies to motor capacitors meant for connection to windings of asynchronous motors supplied from a single-phase system, having a frequency up to 100 Hz, and to capacitors to be connected to a three-phase asynchronous motors so that these motors may be supplied from a single-phase system. Coverage includes definitions, visual examination, check of dimensions, sealing test, endurance test, destruction test, mechanical tests, and tangent of loss angle.