Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
4.1 General requirements
4.2 General requirements concerning insulating
materials
4.3 Additional requirements
5 Type tests
5.1 General
5.2 Visual check
5.3 Dimensional check
5.4 Impact tests
5.5 Dielectric tests
5.6 Indentation test (for insulated tools)
5.7 Test for adhesion of the insulating material
coating (for insulated tools)
5.8 Flame retardancy test
5.9 Mechanical tests
5.10 Durability of marking
6 Quality assurance plan
6.1 Routine tests
6.2 Sampling tests
6.3 Tools with negative test results
6.4 Records
6.5 Acceptance tests
Annex A (informative) Mechanical strength of insulating
tools
Annex B (informative) Recommendation for use and
in-service care
Annex C (normative) Examples of calculation of the
unwinded length of coating and
acceptable leakage current
Annex D (normative) Sampling procedure
Annex E (normative) Acceptance tests
Annex ZA (normative) Normative references to international
publications with their corresponding
European publications
Bibliography