1 General
1.1 Scope
1.2 Normative references
2 Technical data
2.1 Units and symbols
2.2 Definitions
2.3 Preferred values
2.4 Marking
3 Quality assessment procedures
3.1 General
3.2 Primary stage of manufacture
3.3 Structurally similar inductors
3.4 Qualification approval procedures
3.5 Quality conformance inspection
3.6 Alternative test methods
3.7 Unchecked parameters
4 Test and measurement procedure
4.1 General
4.2 Standard atmospheric conditions
4.3 Drying
4.4 Visual examination and check of dimensions
4.5 Insulation resistance
4.6 Voltage proof
4.7 Inductance
4.8 Insertion loss
4.9 Robustness of terminations
4.10 Resistance to soldering heat
4.11 Solderability (applicable only for
terminations intended to be soldered)
4.12 Rapid change of temperature
4.13 Vibration
4.14 Bump
4.15 Shock
4.16 Container sealing
4.17 Climatic sequence
4.18 Damp heat, steady state
4.19 Temperature rise
4.20 Endurance
4.21 Passive flammability
4.22 Active flammability
4.23 Solvent resistance of marking
4.24 Component solvent resistance
Annex A (normative) Interpretation of sampling plans and
procedures as described in IEC 60410 for use
within the IEC quality assessment system for
electronic components (IECQ)
Annex B (normative) Rules for the preparation of detail
specifications for capacitors and resistors for
electronic equipment
Annex C (normative) Requirements for earth inductors
Annex ZA (normative) Normative references to international
publications with their corresponding European
publications