INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
4.1 Capacitors and other components
4.2 Thermally protected ballasts
5 General notes on tests
6 Classification
7 Marking
7.1 Mandatory markings
7.2 Information to be provided, if applicable
7.3 Other information
8 Protection against accidental contact with live
parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electrical strength
13 Thermal endurance test for windings
14 Ballast heating
15 High-voltage impulse testing
16 Fault conditions
17 Construction
18 Creepage distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
21 Resistance to corrosion
22 No-load output voltage
Annex A (normative) Test to establish whether a
conductive part is a live part which may
cause an electric shock
Annex B (normative) Particular requirements for
thermally protected lamp controlgear
Annex C (normative) Particular requirements for
electronic lamp controlgear with means of
protection against overheating
Annex D (normative) Requirements for carrying out the
heating tests of thermally protected lamp
controlgear
Annex E (normative) Use of constant S other than 4500
in tw tests
Annex F (normative) Draught - proof enclosure
Annex G (normative) Explanation of the derivation of
the values of pulse voltages
Annex H (normative) Tests
Annex I (normative) Method for selection of varistors
Annex K (normative) Additional requirements for built-in
magnetic ballasts with double or reinforced insulation
Annex ZA (normative) Normative references to
international publications with their
corresponding European publications