TS 101 952-1 : 1.1.1

Current

Current The latest, up-to-date edition.

ACCESS NETWORK XDSL SPLITTERS FOR EUROPEAN DEPLOYMENT; PART 1: GENERIC SPECIFICATION OF XDSL OVER POTS SPLITTERS

Available format(s): Hardcopy, PDF

Language(s): English

Published date:

Publisher: European Telecommunications Standards Institute

Table of Contents - (Show below) - (Hide below)

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
  2.1 Normative references
  2.2 Informative references
3 Definitions, symbols and abbreviations
  3.1 Definitions
  3.2 Symbols
  3.3 Abbreviations
4 General functional description of xDSL over POTS splitters
  4.1 Functional diagram
  4.2 High pass block: three alternatives
5 Circuit definitions, testing conditions and methods
  5.1 DC testing conditions
  5.2 AC terminating impedances Z[AC]
  5.3 High pass filter implementation
  5.4 General transmission test set-up
  5.5 Unbalance measurement
  5.6 Noise measurement
  5.7 Common Mode Rejection Ratio measurement
6 Splitter requirements
  6.1 Options for splitter requirements
  6.2 DC requirements
  6.3 Ringing frequency requirements
  6.4 POTS pass band loss requirements (on-hook)
  6.5 POTS pass band loss requirements (off-hook)
  6.6 POTS pass band return loss requirements (off-hook)
  6.7 Requirements relating to metering pulses at 12 kHz or
       16 kHz (optional)
  6.8 Unbalance about Earth
  6.9 xDSL band requirements
  6.10 Noise levels
  6.11 Distortion
  6.12 Group delay distortion
  6.13 POTS transient effects (informative)
  6.14 Requirements for Common Mode Rejection (optional)
  6.15 Requirements for Crosstalk at the LE (optional)
Annex A (normative): xDSL specific information
      A.1 Z[DSL] and Z[RefDSL] for specific xDSL over POTS variants
      A.2 Common requirements for passive POTS splitters
      A.3 Specific requirements for passive splitters for ADSL over
          POTS variants
      A.4 Specific requirements for passive splitters for VDSL1
          over POTS variants
      A.5 Specific requirements for passive splitters for VDSL2
          over POTS variants at the TE side
      A.6 Specific requirements for passive splitters for VDSL2
          over POTS variants at the LE side
Annex B (informative): Evolution of the documents
Annex C (informative): Use of the present document for splitters at
        the cabinet
Annex D (informative): Intrinsic IL and RL caused by Z[DSL] in the
        POTS band
Annex E (informative): IL Measurement from LINE to xDSL inside
        Z[DSL]
Annex F (informative): Return Loss measurements: practical diagrams
Annex G (informative): Insertion Loss measured with feeding and
        loading bridges
Annex H (informative): Dynamic tests of splitters in the presence
        of xDSL transceivers (WT-127 of the Broadband Forum)
      H.1 General description
      H.2 Detailed description
Annex I (informative): Optimal transmission of POTS and xDSL
        signals and their separation
Annex J (informative): More on feeding and loading bridges
Annex K (informative): Additional requirements for Active Splitter
        (F.F.S.)
      K.1 Bidirectional IL tests
      K.2 Noise measurements methods for active splitters
      K.3 (6.10) Noise requirements for active splitters
      K.4 (6.11) Distortion
      K.5 (6.13) Transitional tests
Annex L (informative): Bibliography
History

Abstract - (Show below) - (Hide below)

Defines requirements and test methods for the low pass and high pass part of xDSL over POTS splitters.

General Product Information - (Show below) - (Hide below)

Committee	ATTM TM6
Document Type	Standard
ISBN
Pages
Published
Publisher	European Telecommunications Standards Institute
Status	Current

Standards Referenced By This Book - (Show below) - (Hide below)

TR 102 702 : 1.1.1	ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM) STUDY OF ISSUES RELATED TO POTS INJECTION IN THE CUSTOMER WIRING FROM XDSL VOIP HOME GATEWAY
TS 101 548 : 2.1.1	ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); EUROPEAN REQUIREMENTS FOR REVERSE POWERING OF REMOTE ACCESS EQUIPMENT
TS 101 952-4 : 1.1.1	ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); ACCESS NETWORK XDSL SPLITTERS FOR EUROPEAN DEPLOYMENT; PART 4: SPECIFICATION FOR DYNAMIC DISTRIBUTED FILTERS FOR XDSL OVER POTS
TS 101 952-3 : 1.1.1	ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); ACCESS NETWORK XDSL SPLITTERS FOR EUROPEAN DEPLOYMENT; PART 3: GENERIC SPECIFICATION OF STATIC DISTRIBUTED FILTERS FOR XDSL OVER POTS
TS 101 952-2 : 1.1.1	ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); ACCESS NETWORK XDSL SPLITTERS FOR EUROPEAN DEPLOYMENT; PART 2: GENERIC SPECIFICATION OF XDSL OVER ISDN SPLITTERS AND XDSL UNIVERSAL SPLITTERS

Standards Referencing This Book - (Show below) - (Hide below)

TR 101 953-2-1 : 1.1.1	ACCESS NETWORK XDSL TRANSMISSION FILTERS; PART 2: VDSL SPLITTERS FOR EUROPEAN DEPLOYMENT; SUB-PART 1: SPECIFICATION OF TESTING METHODS FOR LOW PASS PART OF VDSL/POTS SPLITTERS
TR 101 953-2-2 : 1.1.1	ACCESS NETWORK XDSL TRANSMISSION FILTERS; PART 2: VDSL SPLITTERS FOR EUROPEAN DEPLOYMENT; SUB-PART 2: SPECIFICATION OF TESTING METHODS FOR HIGH PASS PART OF VDSL/POTS SPLITTERS
EN 300 001 : 1.5.1	ATTACHMENTS TO THE PUBLIC SWITCHED TELEPHONE NETWORK (PSTN) GENERAL TECHNICAL REQUIREMENTS FOR EQUIPMENT CONNECTED TO AN ANALOGUE SUBSCRIBER INTERFACE IN THE PSTN
ES 203 021-3 : 2.1.2	ACCESS AND TERMINALS (AT); HARMONIZED BASIC ATTACHMENT REQUIREMENTS FOR TERMINALS FOR CONNECTION TO ANALOGUE INTERFACES OF THE TELEPHONE NETWORKS; UPDATE OF THE TECHNICAL CONTENTS OF TBR 021, EN 301 437, TBR 015, TBR 017; PART 3: BASIC INTERWORKING WITH THE PUBLIC TELEPHONE NETWORKS
ES 202 971 : 1.2.1	ACCESS AND TERMINALS (AT); PUBLIC SWITCHED TELEPHONE NETWORK (PSTN); HARMONIZED SPECIFICATION OF PHYSICAL AND ELECTRICAL CHARACTERISTICS OF A 2-WIRE ANALOGUE INTERFACE FOR SHORT LINE INTERFACE
ES 201 970 : 1.1.1	ACCESS AND TERMINALS (AT); PUBLIC SWITCHED TELEPHONE NETWORK (PSTN); HARMONIZED SPECIFICATION OF PHYSICAL AND ELECTRICAL CHARACTERISTICS AT A 2-WIRE ANALOGUE PRESENTED NETWORK TERMINATION POINT (NTP)
TR 101 953-1-1 : 1.1.1	ACCESS AND TERMINALS (AT); UNIFIED AND GENERIC TESTING METHODS FOR EUROPEAN SPECIFIC DSL SPLITTERS; PART 1: ADSL SPLITTERS FOR EUROPEAN DEPLOYMENT; SUB-PART 1: SPECIFICATION OF TESTING METHODS FOR LOW PASS PART OF ADSL/POTS SPLITTERS
EG 201 188 : 1.2.1	PUBLIC SWITCHED TELEPHONE NETWORK (PSTN) - NETWORK TERMINATION POINT (NTP) ANALOGUE INTERFACE - SPECIFICATION OF PHYSICAL AND ELECTRICAL CHARACTERISTICS AT A 2-WIRE ANALOGUE PRESENTED NTP FOR SHORT TO MEDIUM LENGTH LOOP APPLICATIONS
ES 201 729 : 1.1.1	PUBLIC SWITCHED TELEPHONE NETWORK (PSTN); 2-WIRE ANALOGUE VOICE BAND SWITCHED INTERFACES; TIMED BREAK RECALL (REGISTER RECALL); SPECIFIC REQUIREMENTS FOR TERMINALS
TS 102 080 : 1.4.1	TRANSMISSION AND MULTIPLEXING (TM); INTEGRATED SERVICES DIGITAL NETWORK (ISDN) BASIC RATE ACCESS; DIGITAL TRANSMISSION SYSTEM ON METALLIC LOCAL LINES
TR 101 953-1-2 : 1.1.1	ACCESS NETWORK XDSL TRANSMISSION FILTERS; PART 1: ADSL SPLITTERS FOR EUROPEAN DEPLOYMENT; SUB-PART 2: TESTING METHODS FOR HIGH PASS PART OF ADSL/POTS SPLITTERS
TR 102 139 : 1.1.1	COMPATIBILITY OF POTS TERMINAL EQUIPMENT WITH XDSL SYSTEMS
TBR 038 : 20001	PUBLIC SWITCHED TELEPHONE NETWORK (PSTN) - ATTACHMENT REQUIREMENTS FOR A TERMINAL EQUIPMENT INCORPORATING AN ANALOGUE HANDSET FUNCTION CAPABLE OF SUPPORTING THE JUSTIFIED CASE SERVICE WHEN CONNECTED TO THE ANALOGUE INTERFACE OF THE PSTN IN EUROPE
ES 201 187 : 1.1.1	2-WIRE ANALOGUE VOICE BAND INTERFACES - LOOP DISCONNECT (LD) DIALLING SPECIFIC REQUIREMENTS
TS 101 270-1 : 1.4.1	TRANSMISSION AND MULTIPLEXING (TM); ACCESS TRANSMISSION SYSTEMS ON METALLIC ACCESS CABLES; VERY HIGH SPEED DIGITAL SUBSCRIBER LINE (VDSL); PART 1: FUNCTIONAL REQUIREMENTS
TR 101 728 : 1.2.1	ACCESS AND TERMINALS; STUDY FOR THE SPECIFICATION OF THE LOW PASS SECTION OF POTS/ADSL SPLITTERS

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Add To Cart

Product Format

Quantity

Buy now

Add to cart

Create account