• TS 151 010-1 : 12.7.0

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    DIGITAL CELLULAR TELECOMMUNICATIONS SYSTEM (PHASE 2+) (GSM); MOBILE STATION (MS) CONFORMANCE SPECIFICATION; PART 1: CONFORMANCE SPECIFICATION (3GPP TS 51.010-1 VERSION 13.6.0 RELEASE 13)

    Available format(s):  Hardcopy, PDF

    Superseded date:  02-10-2019

    Language(s):  English

    Published date: 

    Publisher:  European Telecommunications Standards Institute

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Intellectual Property Rights
    Foreword
    Modal verbs terminology
    Foreword
    1 Scope
    2 References
    3 Definitions, conventions and applicability
    4 Test Equipment
    5 Testing methodology in general (layers 1, 2, and 3)
    6 Reference test methods
    7 Implicit testing
    8 Measurement uncertainty
    9 Format of tests
    10 Generic call set up procedures
    11 General tests
    12 Transceiver
    13 Transmitter
    14 Receiver
    15 Timing advance and absolute delay
    16 Reception time tracking speed
    17 Access times during handover
    18 Temporary reception gaps
    19 Channel release after unrecoverable errors
    20 Cell selection and reselection
    21 Received signal measurements
    22 Transmit power control timing and confirmation
    23 Single frequency reference
    24 Tests of the layer 1 signalling functions
    25 Tests of the layer 2 signalling functions
    26 Testing of layer 3 functions
    27 Testing of the SIM/ME interface
    28 Test of autocalling restrictions
    29 Testing of bearer services
    30 Speech teleservices
    31 Test of supplementary services
    32 Testing of speech transcoding functions
    33 Mobile station features
    34 Short message service (SMS)
    35 Low battery voltage detection
    36 Individual equipment type requirements and
        interworking - special conformance testing
        functions
    37 to 39 Void
    40 GPRS default conditions, message contents and macros
    41 GPRS Paging, TBF establishment/release and
        DCCH related procedures
    42 Test of Medium Access Control (MAC) protocol
    43 RLC Test Cases
    44 Test case requirements for GPRS mobility management
    45 Session Management Procedures
    46 LLC and SNDCP Tests
    47 Dual Transfer Mode
    48 to 49 Void
    50 EGPRS Default Conditions, Message Contents and Macros
    51 EGPRS Paging, TBF establishment/release and
        DCCH related procedures
    52 EGPRS Test of Medium Access Control (MAC) protocol
    53 Test of EGPRS Radio Link Control (RLC) Protocol
    54 to 56 Void
    57 EGPRS Dual Transfer Mode
    58 Void
    58a Latency reductions
    58b Downlink Dual Carrier and Downlink Multi Carrier
    58c EGPRS
    58d EFTA
    58e DTR
    59 Void
    60 Inter-system hard handover from GSM to UTRAN
    61-69 Void
    70 Location Services
    80 Generic Access default conditions, message
        contents and macros
    81 GAN Discovery and Registration Procedures
    82 GAN CS Domain Procedures
    83 GAN PS Domain Procedures
    84 GAN Iu Mode Procedures
    90 Text Telephony (TTY) Services
    Annex 1 (normative) - Reference test methods
    Annex 2 - Void
    Annex 3 - Protocol implementation information
    Annex 4 - Test SIM Parameters
    Annex 4A - Test USIM Parameters
    Annex 5 - Test equipment
    Annex 6 (informative) - E-OTD Accuracy Measurement
            Test Environment
    Annex 7 (informative) - General rules for statistical
            testing
    Annex 8 - Void
    Annex 9 (normative) - GAN certificate
    Annex 10 (informative) - Repeated SACCH Layer 1
             Test Method
    Annex B (informative) - Change History
    History

    Abstract - (Show below) - (Hide below)

    Defines the technical characteristics and methods of test for Mobile Stations (MS), for the Pan European digital cellular communications system and Personal Communication Systems (PCS) operating in the 400 MHz, 700 MHz, 810 MHz, 850 MHz, 900 MHz, 1800 MHz and 1900 MHz band (GSM 450, GSM 480, GSM 710, GSM 750, T-GSM 810, GSM 850, R-GSM 900, ER-GSM 900, GSM 900, DCS 1800 and PCS 1900), standardized by ETSI Special Mobile Group (SMG).

    General Product Information - (Show below) - (Hide below)

    Committee 3GPP RAN 5
    Document Type Standard
    Publisher European Telecommunications Standards Institute
    Status Superseded

    Standards Referenced By This Book - (Show below) - (Hide below)

    I.S. EN 16062:2015 INTELLIGENT TRANSPORT SYSTEMS - ESAFETY - ECALL HIGH LEVEL APPLICATION REQUIREMENTS (HLAP) USING GSM/UMTS CIRCUIT SWITCHED NETWORKS
    BS ISO 26683-2:2013 Intelligent transport systems. Freight land conveyance content identification and communication Application interface profiles
    TR 103 265 : 1.2.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); DEFINITION OF RADIO PARAMETERS
    EN 301 489-50 : 2.1.1 ELECTROMAGNETIC COMPATIBILITY (EMC) STANDARD FOR RADIO EQUIPMENT AND SERVICES; PART 50: SPECIFIC CONDITIONS FOR CELLULAR COMMUNICATION BASE STATION (BS), REPEATER AND ANCILLARY EQUIPMENT; HARMONISED STANDARD COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.1(B) OF DIRECTIVE 2014/53/EU
    EG 202 396-1 : 1.2.4 SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); SPEECH QUALITY PERFORMANCE IN THE PRESENCE OF BACKGROUND NOISE; PART 1: BACKGROUND NOISE SIMULATION TECHNIQUE AND BACKGROUND NOISE DATABASE
    TS 102 936-1 : 1.1.1 ECALL NETWORK ACCESS DEVICE (NAD) CONFORMANCE SPECIFICATION; PART 1: PROTOCOL TEST SPECIFICATION
    TR 102 914 : 1.1.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); ASPECTS AND IMPLICATIONS OF THE INCLUSION OF RECEIVER PARAMETERS WITHIN ETSI STANDARDS
    TS 103 428 : 1.1.1 MOBILE STANDARDS GROUP (MSG); ECALL HLAP INTEROPERABILITY TESTING
    TS 103 412 : 1.2.1 MOBILE STANDARDS GROUP (MSG); PAN-EUROPEAN ECALL END TO END AND IN-BAND MODEM CONFORMANCE TESTING; PROSE TEST SPECIFICATION
    ES 202 396-1 : 1.6.1 SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); SPEECH QUALITY PERFORMANCE IN THE PRESENCE OF BACKGROUND NOISE; PART 1: BACKGROUND NOISE SIMULATION TECHNIQUE AND BACKGROUND NOISE DATABASE
    10/30214021 DC : 0 BS EN 16062 - INTELLIGENT TRANSPORT SYSTEMS - ESAFETY - ECALL HIGH LEVEL APPLICATION REQUIREMENTS (HLAP)
    DIN EN 16062:2015-08 Intelligent transport systems - ESafety - eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
    EN 301 511 : 12.1.1 GLOBAL SYSTEM FOR MOBILE COMMUNICATIONS (GSM); MOBILE STATIONS (MS) EQUIPMENT; HARMONISED STANDARD COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF DIRECTIVE 2014/53/EU
    12/30242166 DC : 0 BS ISO 26683-2 - INTELLIGENT TRANSPORT SYSTEMS - FREIGHT AND CONVEYANCE CONTENT IDENTIFICATION AND COMMUNICATION - PART 2: APPLICATION INTERFACE PROFILES
    TR 102 627 : 1.1.1 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); SYSTEM REFERENCE DOCUMENT; LAND MOBILE SERVICE; ADDITIONAL SPECTRUM REQUIREMENTS FOR PMR/PAMR SYSTEMS OPERATED BY RAILWAY COMPANIES (GSM-R)
    EN 16062:2015 Intelligent transport systems - ESafety - eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
    UNE-EN 16062:2015 Intelligent transport systems - ESafety - eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
    BS EN 16062:2015 Intelligent transport systems. ESafety. eCall high level application requirements (HLAP) using GSM/UMTS circuit switched networks
    ISO 26683-2:2013 Intelligent transport systems — Freight land conveyance content identification and communication — Part 2: Application interface profiles

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO 3:1973 Preferred numbers Series of preferred numbers
    ISO/IEC 7816-3:2006 Identification cards — Integrated circuit cards — Part 3: Cards with contacts — Electrical interface and transmission protocols
    ETR 200028 : 20002 RADIO EQUIPMENT & SYSTEMS (RES) - UNCERTAINTIES IN THE MEASUREMENT OF MOBILE RADIO EQUIPMENT CHARACTERISTICS
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective