|
EN 1254-3:1998
|
Copper and copper alloys - Plumbing fittings - Part 3: Fittings with compression ends for use with plastics pipes |
|
EN 681-1:1996/A3:2005
|
ELASTOMERIC SEALS - MATERIALS REQUIREMENTS FOR PIPE JOINT SEALS USED IN WATER AND DRAINAGE APPLICATIONS - PART 1: VULCANIZED RUBBER |
|
ISO 1133-1:2011
|
Plastics Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics Part 1: Standard method |
|
ISO 1167-4:2007
|
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 4: Preparation of assemblies |
|
ISO 9080:2012
|
Plastics piping and ducting systems — Determination of the long-term hydrostatic strength of thermoplastics materials in pipe form by extrapolation |
|
EN 681-2:2000/A2:2005
|
ELASTOMERIC SEALS - MATERIALS REQUIREMENTS FOR PIPE JOINT SEALS USED IN WATER AND DRAINAGE APPLICATIONS - PART 2: THERMOPLASTIC ELASTOMERS |
|
ISO/TS 15876-7:2003
|
Plastics piping systems for hot and cold water installations Polybutylene (PB) Part 7: Guidance for the assessment of conformity |
|
ISO 15876-1:2017
|
Plastics piping systems for hot and cold water installations — Polybutene (PB) — Part 1: General |
|
ISO 3126:2005
|
Plastics piping systems Plastics components Determination of dimensions |
|
ISO 1167-3:2007
|
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 3: Preparation of components |
|
EN 1254-6:2012
|
Copper and copper alloys - Plumbing fittings - Part 6: Fittings with push-fit ends |
|
CEN/TR 12108:2012
|
Plastics piping systems - Guidance for the installation inside buildings of pressure piping systems for hot and cold water intended for human consumption |
|
ISO 15876-2:2017
|
Plastics piping systems for hot and cold water installations — Polybutene (PB) — Part 2: Pipes |
|
EN 10226-1:2004
|
Pipe threads where pressure tight joints are made on the threads - Part 1: Taper external threads and parallel internal threads - Dimensions, tolerances and designation |
|
ISO 15876-5:2017
|
Plastics piping systems for hot and cold water installations — Polybutene (PB) — Part 5: Fitness for purpose of the system |
|
ISO 228-1:2000
|
Pipe threads where pressure-tight joints are not made on the threads Part 1: Dimensions, tolerances and designation |
|
ISO 7686:2005
|
Plastics pipes and fittings — Determination of opacity |
|
EN 10088-1:2014
|
Stainless steels - Part 1: List of stainless steels |
|
ISO 1167-1:2006
|
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids Determination of the resistance to internal pressure Part 1: General method |
|
EN 1254-8:2012
|
Copper and copper alloys - Plumbing fittings - Part 8: Fittings with press ends for use with plastics and multilayer pipes |