UNI ISO 8013 : 2013

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

RUBBER, VULCANIZED - DETERMINATION OF CREEP IN COMPRESSION OR SHEAR

Available format(s):

Superseded date: 30-09-2022

Language(s):

Published date: 01-01-2013

Publisher: Ente Nazionale Italiano di Unificazione (UNI)

Table of Contents - (Show below) - (Hide below)

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Apparatus
5 Calibration
6 Test piece
7 Time-lapse between vulcanization and testing
8 Mechanical conditioning
9 Test temperature
10 Procedure
11 Calculation of results
12 Expression of results
13 Test report
Annex A (informative) - Values of forces required for rubbers
of different hardnesses
Annex B (normative) - Calibration schedule
Bibliography

Abstract - (Show below) - (Hide below)

Describes a method for the determination of creep in vulcanized rubber continuously subjected to compressive or to shear forces.

General Product Information - (Show below) - (Hide below)

Development Note	Supersedes UNI 5610 and UNI ISO 815. (07/2008)
Document Type	Standard
ISBN
Pages
Published
Publisher	Ente Nazionale Italiano di Unificazione (UNI)
Status	Superseded
Superseded By	UNI ISO 8013:2019
Supersedes	UNI ISO 815 : 2001 UNI 5610 : 1965 UNI ISO 8013 : 2008

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 8013:2012	Identical

Standards Referencing This Book - (Show below) - (Hide below)

ISO 23529:2016	Rubber General procedures for preparing and conditioning test pieces for physical test methods
ISO 815-1:2014	Rubber, vulcanized or thermoplastic Determination of compression set Part 1: At ambient or elevated temperatures
ISO 1827:2016	Rubber, vulcanized or thermoplastic — Determination of shear modulus and adhesion to rigid plates — Quadruple-shear methods
ISO 4664-1:2011	Rubber, vulcanized or thermoplastic — Determination of dynamic properties — Part 1: General guidance
ISO 18899:2013	Rubber — Guide to the calibration of test equipment

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart