Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Health and safety
5 Principle
6 Testing requirements
7 Test report
Annex A (normative) - Types of test piece to be used for sheet
and strip with thickness less than or equal to 8 mm
Annex B (normative) - Types of non-machined test piece to be
used in the case of bar, section and wire with a
diameter or thickness less than or equal to 8 mm
Annex C (normative) - Types of machined test piece to be used
in the case of bar, section, plate and wire with
diameter or thickness greater than 8 mm and for
forgings and castings
Annex D (normative) - Types of test piece to be used in the case
of tubes