BS EN 10160:1999

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Personnel
6 Apparatus
7 Coupling conditions - Surface condition of the flat
    Product
8 Scanning plan
9 Procedure
10 Acceptance criteria
11 Test report
Annex A (informative) List of equivalent terms in
                      several European Languages

Addresses a procedure for the ultrasonic testing of uncoated flat steel product for internal discountinuities. Applies to flat product in nominal thickness range of 6mm to 200mm of alloyed or non-alloyed steel, excluding austenoferritic or austenitic steels, provided that the difference between the amplitude of the noise signal and that of the the echo detection threshold is sufficient for the limit fixed. Also specifies four quality classes for the flat product body and five for the edges.

This European Standard describes a method for the ultrasonic testing of uncoated flat steel product for internal discontinuities. It is applicable to flat product in nominal thickness range of 6 mm to 200 mm of non-alloyed or alloyed steel, excluding austenitic or austenoferritic steels. However, this standard may be applied to the latter types of steels provided that the difference between the amplitude of the noise signal and that of the echo detection threshold is sufficient for the limit fixed.

This standard also defines four quality classes for the flat product body (classes S₀, S₁, S₂ and S₃) and 5 classes (E₀, E₁, E₂, E₃, E₄) for the edges in accordance with the criteria specified in clause 9.

Other methods of testing (e.g. by transmission) or other test equipment may be used at the manufacturer\'s discretion provided that they give identical results to those obtained under the conditions of this standard. In the event of a dispute, only the method defined in this standard shall prevail.

Testing of flat product of thickness less than 6 mm may be the subject of special agreements between the parties concerned.

The inspection is normally carried out in the place of production or on the premises of the supplier. If specified on the order, the inspection may take place in the presence of the purchaser or his representative¹⁾.

A list of equivalent terms in several European languages is given in annex A.