Skip to content
Please enter a keyword to search

  • PD CEN/TS 16650:2014

    Current The latest, up-to-date edition.

    Specification for hose couplings for petrol, oil and lubricants. High pressure couplings

    Available format(s):  Hardcopy, PDF

    Language(s):  English

    Published date:  30-06-2014

    Publisher:  British Standards Institution

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    1 Scope
    2 Normative references
    3 Information to be supplied by the purchaser
    4 Designation of sizes of couplings
    5 Materials
    6 Dimensions
    7 Coupling finish
    8 Screw threads
    9 Washers
    10 Bonding
    11 Hydrostatic test
    12 Identification marking

    Abstract - (Show below) - (Hide below)

    Defines requirements for couplings of 2 in (50,8 mm), 2[1/2] in (63,5 mm), 3 in (76,2 mm) and 4 in (101,6 mm) nominal sizes with ribbed tails and hexagons for use at pressures not exceeding 1550 kN/m[2] (225 lbf/in[2]).

    Scope - (Show below) - (Hide below)

    This Technical Specification specifies requirements for couplings of 2 in (50,8 mm), 2½ in (63,5 mm), 3 in (76,2 mm) and 4 in (101,6 mm) nominal sizes with ribbed tails and hexagons for use at pressures not exceeding 1 550 kN/m2 (225 lbf/in2). For assembly of coupling, see Figure 1. This document is applicable to couplings which have been designed primarily for aircraft refuelling purposes, but they may also be used for other general purposes.

    General Product Information - (Show below) - (Hide below)

    Committee PRI/66
    Development Note Supersedes BS 2464-2(1969). (06/2014)
    Document Type Standard
    Publisher British Standards Institution
    Status Current
    Supersedes

    Standards Referencing This Book - (Show below) - (Hide below)

    EN ISO 228-2:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 2: Verification by means of limit gauges (ISO 228-2:1987)
    EN ISO 228-1:2003 Pipe threads where pressure-tight joints are not made on the threads - Part 1: Dimensions, tolerances and designation (ISO 228-1:2000)
    BS 1936-1:1952 Undercuts and runouts for screw threads Inch screw threads
    EN 1982:2017 Copper and copper alloys - Ingots and castings
    ISO 228-1:2000 Pipe threads where pressure-tight joints are not made on the threads Part 1: Dimensions, tolerances and designation
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective