EN 301 997-1 : 1.1.1

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
3 Definitions, symbols and abbreviations
  3.1 Definitions
  3.2 Symbols
  3.3 Abbreviations
4 General characteristics
  4.1 General system architecture
  4.2 Frequency bands and channel arrangements
      4.2.1 Frequency plan
      4.2.2 Channel arrangements
  4.3 Compatibility requirements
  4.4 Environmental conditions
      4.4.1 Equipment within weather protected locations
            (indoor locations)
      4.4.2 Equipment for non-weather protected locations
            (outdoor locations)
  4.5 Power supply
  4.6 EMC conditions
  4.7 Synchronization of interface bit rates
  4.8 Antenna/feeder/branching requirements
      4.8.1 Antenna requirements
      4.8.2 Return loss
      4.8.3 Intermodulation products
5 System parameters
  5.1 System capacity
  5.2 Round Trip Delay
  5.3 Voice Coding
  5.4 RF Block Diagram
  5.5 Transmitter characteristics
      5.5.1 Output power
      5.5.2 Power control
            5.5.2.1 Automatic Transmit Power Control (ATPC)
            5.5.2.2 Remote Transmit Power Control (RTPC)
      5.5.3 Remote Frequency Control (RFC)
            5.5.3.1 Out of block emissions caused by RFC setting
            5.5.3.2 Emissions caused by RFC setting inside the
                    block
      5.5.4 RF spectrum mask
            5.5.4.1 Channel spectrum mask
            5.5.4.2 Transmitter block edge mask
      5.5.5 Spurious emissions (external)
      5.5.6 RF tolerance
  5.6 Receiver characteristics
      5.6.1 Spurious emissions (external)
  5.7 System performances
6 Types of interface
Annex A (normative): Intra-block minimum requirements
      A.1 Channel spectrum mask
      A.2 BER as a function of Receiver input Signal Level (RSL)
      A.3 Co-channel interference
      A.4 Adjacent channel interference
Annex B (informative): CEPT/ERC regulatory considerations on EIRP
        and block edge mask
      B.1 General considerations
      B.2 Transmitter maximum EIRP limits
      B.3 Transmitter EIRP spectral density block mask
Annex C (informative): Matched receiver block-edge selectivity mask
      C.1 Receiver block-edge selectivity mask
Annex D (informative): Example of a method for Automatic Transmit
        Power Control (ATPC) in the uplink direction
History

Describes the minimum requirements for equipment and system parameters, including parameters necessary to plan co-existence, of MWS (Multimedia Wireless Systems) operating in the 40,5 GHz to 43,5 GHz frequency band and used for a range of applications including telecommunication and entertainment services.