Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and abbreviated terms
3.1 Terms and definitions
3.2 Symbols and abbreviated terms
4 Requirements
4.1 Quality control instructions
4.2 Records retention
5 Calibration of equipment
5.1 General requirements
5.2 Reagents and materials for calibration
5.3 General requirements for calibration of particular
apparatus
5.4 Frequency of calibration verification
5.5 Calibration verification
6 Density
6.1 General
6.2 Apparatus
6.3 Density measurement by hydrometer
6.4 Density correction to 21 degree C (70 degree F)
6.5 Calculation of density in units other than kg/m[3]
6.6 Calculation for pressure and temperature compensation
7 Crystallization temperature
7.1 Principle
7.2 Apparatus
7.3 Determination of crystallization point
7.4 Calculation of crystallization point
8 Brine clarity
8.1 Principle
8.2 Apparatus
8.3 Determination of brine clarity
9 Solids evaluation by gravimetric procedures
9.1 Principle
9.2 Apparatus
9.3 Preparation of glass-fibre filter disk
9.4 Selection of sample volume
9.5 Determination of total suspended solids
9.6 Calculation of total suspended solids
9.7 Calculation of precision and bias
9.8 Determination of volatile and non-volatile solids
9.9 Calculation of non-volatile and volatile solids
10 pH
10.1 Principle
10.2 Reagents and materials
10.3 Apparatus
10.4 Measurement of pH
10.5 Precision statement
10.6 Care of the electrode
11 Iron contamination
11.1 Principle
11.2 Reagents and materials
11.3 Apparatus
11.4 Preparation of colorimetric standards
11.5 Measurement of iron contamination
11.6 Precision statement
12 Daily completion fluid report
12.1 Principle
12.2 Well identification, geometry and zone data
12.3 System properties
12.4 Fluids accounting
12.5 Cost accounting
12.6 Daily commentary
12.7 Vendor representative identification
Annex A (informative) - Completion fluids report form
Annex B (informative) - Gas hydrates
Annex C (informative) - Buffering capacity of brines
Annex D (informative) - Pressure crystallization of brines
Annex E (informative) - Brine viscosity
Annex F (informative) - Principle of corrosion testing
Bibliography