I.S. EN 17347:2021

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
5 Safety requirements and/or protection measures
6 Verification of the safety requirements and/or measures
7 Information for use
Annex A (informative) Machine examples
Annex B (informative) Type of example of how to protect the control actuators from accidental activation
Annex C (normative) Pictograms to be used
Annex D (normative) Instructions for mounting/demounting UHP (Ultra High Performance) and RF (Run Flat) tyres
Annex E (normative) Noise test code for machines for mounting and demounting vehicle tyres
Annex ZA (informative) Relationship between this European Standard and the essential requirements of Directive 2006/42/EC aimed to be covered
Bibliography

This document specifies the safety requirements and their verification for the design and building of machines (see the definition in 3.1) for mounting and demounting tyres on the vehicles listed below and identified according to the international categories M1, M2, N1, O1, O2, L4 and L5: a) cars b) buses c) lorries d) motor-vehicles for specific or special transport e) mobile homes f) cargo trailers g) car trailers h) motorised quadricycles i) motor vehicles j) mopeds k) agricultural machines (if the wheel/tyre dimensions are compatible with the maximum dimensions indicated in the tyre changer user instructions) The vehicles listed in points a) to f) have an overall full-load mass no greater than 3,5 t.