SAE AMS 4164 : 2013

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

ALUMINUM ALLOY, EXTRUSIONS, 4.4CU - 1.5MG - 0.60MN (2024-T3510), STRESS-RELIEF STRETCHED, UNSTRAIGHTENED

Available format(s): Hardcopy, PDF

Superseded date: 26-07-2019

Language(s): English

Published date: 01-01-2013

Publisher: SAE International

Table of Contents - (Show below) - (Hide below)

1 SCOPE
2 APPLICABLE DOCUMENTS
3 TECHNICAL REQUIREMENTS
4 QUALITY ASSURANCE PROVISIONS
5 PREPARATION FOR DELIVERY
6 ACKNOWLEDGEMENT
7 REJECTIONS
8 NOTES

Abstract - (Show below) - (Hide below)

Specifies an aluminum alloy in the form of extruded bars, wire, rods, shapes, and tubing. Mainly for parts that are subject to excessive warpage during machining, and for parts needing high strength and whose fabrication does not normally involve welding. Certain design and processing procedures may cause these extrusions to become susceptible to stress-corrosion cracking.

General Product Information - (Show below) - (Hide below)

Committee	AMS-D
Document Type	Standard
ISBN
Pages
Published
Publisher	SAE International
Status	Superseded
Superseded By	SAE AMS4164J:2019
Supersedes	SAE AMS 4164 : 2003

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
SAE AMS QQ A 200/3 : 1997	Similar to
QQ-A-200-3 Revision F:1983	Similar to

Standards Referencing This Book - (Show below) - (Hide below)

ANSI H35.2 : 2017	DIMENSIONAL TOLERANCES FOR ALUMINUM MILL PRODUCTS
ASTM B 666/B666M : 2015 : REDLINE	Standard Practice for Identification Marking of Aluminum and Magnesium Products
SAE AMS 2772 : 2016	HEAT TREATMENT OF ALUMINUM ALLOY RAW MATERIALS
SAE AS1990D:2003(S2016)	ALUMINUM ALLOY TEMPERS
SAE AMS 2355 : 2016	QUALITY ASSURANCE, SAMPLING AND TESTING, ALUMINUM ALLOYS AND MAGNESIUM ALLOY, WROUGHT PRODUCTS (EXCEPT FORGING STOCK), AND ROLLED, FORGED, OR FLASH WELDED RINGS
ASTM B 660 : 2015 : REDLINE	Standard Practices for Packaging/Packing of Aluminum and Magnesium Products
ANSI H35.2M : 2013	DIMENSIONAL TOLERANCES FOR ALUMINUM MILL PRODUCTS (METRIC)

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Add To Cart

Product Format

Quantity

Buy now

Add to cart

Create account