SN EN 1636-5 : 1998

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

PLASTICS PIPING SYSTEMS FOR NON-PRESSURE DRAINAGE AND SEWERAGE - GLASS-REINFORCED THERMOSETTING PLASTICS (GRP) BASED ON UNSATURATED POLYESTER RESIN (UP) - PART 5: FITNESS FOR PURPOSE OF THE JOINTS

Available format(s):

Superseded date: 01-05-2006

Language(s):

Published date: 12-01-2013

Publisher: Swiss Standards

Table of Contents - (Show below) - (Hide below)

Foreword
Introduction
1. Scope
2. Normative references
3. Definitions
4. Interchangeability
5. Joints
   5.1 Dimensions
   5.2 Flexible and reduced-articulation joints with
       elastomeric sealing components

Abstract - (Show below) - (Hide below)

Describes the characteristics of the fitness for purpose of glass-reinforced thermosetting plastics based on unsaturated polyester resin (GRP-UP) piping systems intended to be used for non-pressure drainage and sewerage. Also specifies the relevant test parameters for the test methods referred to in this standard which are applicable to the joints to be used in GRP-UP piping systems to be used for the conveyance of surface water or sewage below ground, outside buildings, at temperature up to 50 degree C.

General Product Information - (Show below) - (Hide below)

Document Type	Standard
ISBN
Pages
Published
Publisher	Swiss Standards
Status	Superseded

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
UNE-EN 1636-5:1998	Identical
I.S. EN 1636-5:1998	Identical
EN 1636-5 : 1997	Identical
BS EN 1636-5:2001	Identical
DIN EN 1636-5:1999-12	Identical

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart