INTRODUCTION
1 Scope
2 Normative references
3 Definitions and abbreviations
3.1 Definitions
3.2 Abbreviations used in this standard
3.3 IMO performance standards
4 Minimum performance requirements
4.1 General
4.2 Design and operation
4.3 Power supply
4.4 Durability and resistance to environmental
conditions
4.5 Interference
4.6 Safety precautions
4.7 Maintenance
4.8 Equipment manuals
4.9 Marking and identification
5 Methods of testing and required
5.1 General
5.2 Test conditions
5.3 Test results
6 Operational checks (all equipment categories)
6.1 Ergonomics and HMI
6.2 Hardware
6.3 Software
6.4 Inter-unit connection
7 Power supply - Methods of testing and required test
results
7.1 Extreme power supply
7.2 Excessive conditions
7.3 Power supply short-term variation
7.4 Power supply failure
8 Durability and resistance to environmental
conditions - Methods of testing and required test
results
8.1 General
8.2 Dry heat
8.3 Damp heat
8.4 Low temperature
8.5 Thermal shock (portable equipment)
8.6 Drop (portable equipment)
8.7 Vibration (all equipment categories)
8.8 Rain and spray (exposed equipment)
8.9 Immersion
8.10 Solar radiation (portable equipment)
8.11 Oil resistance (portable equipment)
8.12 Corrosion (salt mist) (all equipment categories)
9 Electromagnetic emission - Methods of testing and
required test results
9.1 General
9.2 Conducted emissions (all equipment categories
except portable)
9.3 Radiated emissions from enclosure port (all
equipment categories except submerged)
10 Immunity to electromagnetic environment - Methods of
testing and required test results
10.1 General
10.2 Radio receiver equipment
10.3 Immunity to conducted radio frequency disturbance
10.4 Immunity to radiated radiofrequencies (all
equipment categories except submerged)
10.5 Immunity to fast transients on a.c. power, signal
and control lines (all equipment categories except
portable)
10.6 Immunity to surges on a.c. power lines (all
equipment categories except portable)
10.7 Immunity to power supply short-term variation (all
equipment categories except portable)
10.8 Immunity to power supply failure (all equipment
categories except portable)
10.9 Immunity to electrostatic discharge (all equipment
categories except submerged)
11 Special purpose tests - Methods of testing and required
test results
11.1 Acoustic noise and signals (all equipment intended
for installation in wheelhouses and bridge wings)
11.2 Compass safe distance (all equipment categories
except submerged)
12 Safety precautions - Methods of testing and required
test results (all equipment categories)
12.1 Protection against accidental access to dangerous
voltages
12.2 Electromagnetic radio frequency radiation
12.3 Emission from visual display unit (VDU)
12.4 X-radiation
13 Maintenance (all equipment categories)
14 Equipment manuals (all equipment categories)
15 Marking and identification (all equipment categories)
Annex A (normative) IMO Resolution A.694(17)
Annex B (informative) Environmental conditions for ships
Annex C (informative) EMC requirements for ships
Annex D (informative) Examples of equipment by
environmental class
Annex E (informative) Test Report
Annex F (informative) Cross-references between the
requirements of IMO Resolution A.694 and the
tests/checks in this standard
Annex G (informative) Summary of significant changes to
test requirements from Edition 3 of IEC 60945
Annex ZA (normative) Normative references to international
publications with their corresponding European
publications
Bibliography