INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
5.1 Starting devices for use with lamps having different
electrical characteristics
5.2 Number of specimens
6 Classification
7 Marking
7.1 Mandatory markings
7.2 Information to be provided, if applicable
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Heating of independent starting devices
15.1 Normal operation
15.2 Abnormal operation
16 Pulse voltage of ignitors
17 Mechanical strength
18 Construction
19 Creepage distances and clearances
20 Screws, current-carrying parts and connections
21 Resistance to heat, fire and tracking
22 Resistance to corrosion
Annex A (normative) Test to establish whether a conductive
part is a live part which may cause an electric shock
Annex B (normative) Particular requirements for thermally
protected lamp controlgear
Annex C (normative) Particular requirements for electronic
lamp controlgear with means of protection against
overheating
Annex D (normative) Requirements for carrying out the
heating tests of thermally protected lamp
controlgear
Annex E (normative) Use of constant S other than 4500 in t[w]
tests
Annex F (normative) Draught-proof enclosure
Annex G (informative) Explanation of the derivation of the
values of pulse voltages
Annex H (normative)
Annex I (normative) Mechanical strength testing
Annex J (normative) Precautions to be observed when measuring
with sphere-gaps
Annex ZA (normative) Normative references to international
publications with their corresponding European
publications
Bibliography