UNE-EN 12165:2017

Foreword
1 Scope
2 Normative References
3 Definitions
3.1 Forging
3.2 Forging stock
3.3 Circularity (round rod)
4 Designations
4.1 Material
4.2 Material condition
4.3 Product
5 Ordering information
6 Requirements
6.1 Composition
6.2 Hardness
6.3 Resistance to dezincification
6.4 Dimensions and tolerances
7 Sampling
7.1 General
7.2 Analysis
7.3 Hardness and dezincification resistance tests
8 Test methods
8.1 Analysis
8.2 Hardness test
8.3 Dezincification resistance test
8.4 Retests for analysis, hardness and
       dezincification resistance
8.5 Rounding of results
9 Declaration of conformity and inspection
       documentation
9.1 Declaration of conformity
9.2 Inspection documentation
10 Marking, labelling, packaging
Annex A (informative) Bibliography
Annex B (normative) Determination of mean depth
        of dezincification
Table 1 - Composition of copper
Table 2 - Composition of low alloyed copper alloys
Table 3 - Composition of copper-zinc alloys
Table 4 - Composition of copper-zinc-lead alloys
Table 5 - Composition of complex copper-zinc alloys
Table 6 - Composition of copper-nickel alloys
Table 7 - Composition of copper-nickel-zinc alloys
Table 8 - Composition of copper-aluminium alloys
Table 9 - Mechanical properties of copper
Table 10 - Mechanical properties of low-alloyed
           copper alloys
Table 11 - Mechanical properties of copper-zinc alloys
Table 12 - Mechanical properties of copper-zinc-lead
           alloys
Table 13 - Mechanical properties of complex
           copper-zinc alloys
Table 14 - Mechanical properties of copper-nickel alloys
Table 15 - Mechanical properties of copper-nickel-zinc
           alloys
Table 16 - Mechanical properties of copper-aluminium
           alloys
Table 17 - Tolerances on diameter
Table 18 - Tolerances on length
Table 19 - Tolerances on straightness of round rod
           supplied to class C tolerances on diameter
Table 20 - Sampling rate

Defines the composition, property requirements and dimensional tolerances for copper and copper alloy round rod supplied in straight lengths, specifically intended for forging. Applies to regular polygonal rod, hollow rod, rectangular bar and profiles intended for forging. Also, covers the sampling procedures, methods of test for verification of conformity to the requirements of this standard and the delivery conditions.