UNE-EN 13782:2016

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements for design, analysis and
   examination
   4.1 Design documents
   4.2 Description of construction and operation
   4.3 Construction drawings
5 Principles of numerical analysis
   5.1 Verification
   5.2 Selection of textile materials
6 Design actions
   6.1 General
   6.2 Permanent actions
   6.3 Conventional load
   6.4 Variable actions
   6.5 Seismic forces
   6.6 Load combinations
7 Verification of stability and equilibrium
   7.1 General
   7.2 Verification against overturning, sliding and
        lifting
   7.3 Dead load for tent covers
   7.4 Structures with primary load bearing structure (i.e.
        roof, truss, tents)
   7.5 Membrane
   7.6 Verification of load bearing capacity of technical
        textiles and their connections
   7.7 Safety margin, safeguards
   7.8 Post tensioning
8 Ground anchorages
   8.1 General
   8.2 Load bearing capacity of weight anchors
   8.3 Load bearing capacity of rod anchors
   8.4 Testing of anchors
9 Other structural components
   9.1 Cables, ropes, chains, safety devices
   9.2 Accessories
   9.3 Ratchets
   9.4 Detail connections
10 Special design and manufacture criteria
11 Manufacture and supply
   11.1 General
   11.2 Certificates
   11.3 Observation of the design specification
   11.4 Description of installation and operation procedures
12 Examination
   12.1 General
   12.2 Qualification
   12.3 Competence
13 Procedures for approval, examination and tests
   13.1 General
   13.2 Identification
   13.3 Initial approval of tents
   13.4 Inspection after repair, modification and accidents
   13.5 Report
14 Tent book
   14.1 General
   14.2 Content
15 Use and operation
Annex A (informative) Burning behaviour
Annex B (informative) Aerodynamic coefficients for round
                      shape tents
Annex C (informative) Special design and manufacture criteria
      C.1 Access to and egress from enclosures, shows and
          others
      C.2 Burning behaviour
      C.3 Connection and weldings
Annex D (informative) Use and operation
      D.1 Periodic thorough examination
      D.2 Installation examination
      D.3 Escape routes
      D.4 Stairs
      D.5 Heating and cooking systems
      D.6 Electrical fittings
      D.7 Fire extinguishers
Bibliography

Describes safety requirements which need to be observed at design, calculation, manufacture, installation, maintenance, operation, examination and testing of mobile, temporary installed tents more than 50 m[2] ground area.