09/30189100 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN 60917-2-4 - MODULAR ORDER FOR THE DEVELOPMENT OF MECHANICAL STRUCTURES FOR ELECTRONIC EQUIPMENT PRACTICES - PART 2-4: SECTIONAL SPECIFICATION - INTERFACE COORDINATION DIMENSIONS FOR THE 25 MM EQUIPMENT PRACTICE - ADAPTATION DIMENSIONS FOR SUBRACKS APPLICABLE IN CABINETS IN ACCORDANCE WITH IEC 60297-3-100 (19 IN)
Hardcopy , PDF
31-05-2010
English
FOREWORD
Introduction
1 Scope and object
2 Normative references
3 Arrangement overview and definitions
4 Dimensions for adaptor flanges of the specific metric
subracks or chassis (suitable only where WS1 = 425 mm)
mountable into 19 in cabinets or racks
4.1 Dimensions for mounting holes arrangements
on the flanges, mounting layout referred to
the bottom pitch lines of the metric subracks
or chassis
4.2 Dimensions for mounting holes arrangements
on the adaptor flanges, mounting layout
referred to the unit centre lines of the
metric subracks or chassis
BS EN 60917-2-4
Committee |
EPL/48
|
DocumentType |
Draft
|
Pages |
16
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy |
IEC 60950-1:2005+AMD1:2009+AMD2:2013 CSV | Information technology equipment - Safety - Part 1: General requirements |
IEC 60297-3-101:2004 | Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-101: Subracks and associated plug-in units |
IEC 60297-1:1986 | Dimensions of mechanical structures of the 482.6 mm (19 in) series. Part 1: Panels and racks |
IEC 60917-2-1:1993 | Modular order for the development of mechanical structures for electronic equipment practices - Part 2: Sectional specification - Interface co-ordination dimensions for the 25 mm equipment practice - Section 1: Detail specification - Dimensions for cabinets and racks |
IEC 60917-2-2:1994 | Modular order for the development of mechanical structures for electronic equipment practices - Part 2: Sectional specification - Interface co-ordination dimensions for the 25 mm equipment practice - Section 2: Detail specification - Dimensions for subracks, chassis, backplanes, front panels and plug-in units |
IEC 60297-2:1982 | Dimensions of mechanical structures of the 482.6 mm (19 in) series. Part 2: Cabinets and pitches of rack structures |
IEC 60297-3-100:2008 | Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-100: Basic dimensions of front panels, subracks, chassis, racks and cabinets |
IEC 60917-1:1998+AMD1:2000 CSV | Modular order for the development of mechanical structures for electronic equipment practices - Part 1: Generic standard |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.