![header thumbnail](/images/publishers\bsi_cover.gif)
09/30192596 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
![header thumbnail](/images/publishers\bsi_cover.gif)
BS 4500 - LIMITS AND FITS - GUIDANCE FOR SYSTEM OF CONE (TAPER) FITS AND TOLERANCES FOR CONES FROM C = 1:3 TO 1:500, LENGTHS FROM 6 MM TO 630 MM AND DIAMETERS UP TO 500 MM
Hardcopy , PDF
30-09-2009
English
Foreword
Section 1: General
1 Scope
2 Normative references
3 Terms and definitions
Section 2: System of cone fits
4 Formation of cone fits
5 Calculation of axial displacements for
the hole basis system of cone fits
Section 3: System of cone tolerances
6 Cone diameter tolerance T[D]
7 Cone angle tolerance AT
8 Cone form tolerances T[F]
9 Cone section diameter tolerance T[DS]
10 Table of cone angle tolerances - structure
of the table
Annexes
Annex A (informative) - Effect on the cone fit of departures
of the internal and external cones from the basic cone
Annex B (informative) - Maximum cone angle deviations
resulting from the cone diameter tolerances (T[D]) for
100 mm cone length
Bibliography
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.