Skip to content
Please enter a keyword to search

  • 11/30229142 DC : 0

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    BS ISO 10300-3 - CALCULATION OF LOAD CAPACITY OF BEVEL GEARS - PART 3: CALCULATION OF TOOTH ROOT STRENGTH

    Available format(s):  Hardcopy, PDF

    Superseded date:  31-03-2014

    Language(s):  English

    Published date: 

    Publisher:  British Standards Institution

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    Introduction
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Symbols and abbreviated terms
    5 General rating procedure
    6 Gear tooth rating formulae - Method B1
    7 Gear tooth rating formulae - Method B2
    8 Factors for permissible tooth root stress common
      for Method B1 and Method B2
    Annex A (informative) - Graphs of tooth form factor
            Y[Fa] as well as combined tooth form factor
            Y[FS] = Y[Fa] Y[Sa] - Method B1
    Annex B (informative) - Graphs of bevel gear geometry
            factor, Y[J] - Method B2
    Annex C (informative) - Graphs of hypoid gear geometry
            factor, Y[J] - Method B2

    Abstract - (Show below) - (Hide below)

    Describes the fundamental formulae for use in the tooth root stress calculation of straight and helical (skew), zerol and spiral bevel gears and hypoid gears with a minimum rim thickness under the root of 3,5 m[mn].

    General Product Information - (Show below) - (Hide below)

    Comment Closes On
    Committee MCE/5/-/13
    Document Type Draft
    Publisher British Standards Institution
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO 6336-3:2006 Calculation of load capacity of spur and helical gears Part 3: Calculation of tooth bending strength
    ISO 6336-5:2016 Calculation of load capacity of spur and helical gears Part 5: Strength and quality of materials
    ISO 10300-1:2014 Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
    ISO 23509:2016 Bevel and hypoid gear geometry
    ISO 10300-2:2014 Calculation of load capacity of bevel gears — Part 2: Calculation of surface durability (pitting)
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective