13/30266458 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN ISO 14373 - RESISTANCE WELDING - PROCEDURE FOR SPOT WELDING OF UNCOATED AND COATED LOW CARBON STEELS
Hardcopy , PDF
31-03-2015
English
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols and abbreviated terms
5 Material
6 Surface conditions
7 Edge conditions, form of component, and weld spacing
8 Electrodes
9 Weld assessment
10 Weld quality requirements
11 Multi-weld arrays
Annex A (informative) - Recommendations for spot welding
equipment
Annex B (informative) - Typical spot welding conditions
Annex C (informative) - Partial list of steel types applicable
to this International Standard
Annex D (informative) - Typical failure modes and definition
of weld diameters
Bibliography
BS EN ISO 14373
| Committee |
WEE/-/1
|
| DocumentType |
Draft
|
| Pages |
26
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 5182:2016 | Resistance welding Materials for electrodes and ancillary equipment |
| ISO 14270:2016 | Resistance welding Destructive testing of welds Specimen dimensions and procedure for mechanized peel testing resistance spot, seam and embossed projection welds |
| ISO 10447:2015 | Resistance welding — Testing of welds — Peel and chisel testing of resistance spot and projection welds |
| ISO 3574:2012 | Cold-reduced carbon steel sheet of commercial and drawing qualities |
| ISO 3573:2012 | Hot-rolled carbon steel sheet of commercial and drawing qualities |
| ISO 9364:2011 | Continuous hot-dip 55 % aluminium/zinc alloy-coated steel sheet of commercial, drawing and structural qualities |
| ISO 4998:2014 | Continuous hot-dip zinc-coated and zinc-iron alloy-coated carbon steel sheet of structural quality |
| ISO 5002:2013 | Hot-rolled and cold-reduced electrolytic zinc-coated carbon steel sheet of commercial and drawing qualities |
| ISO 15614-12:2014 | Specification and qualification of welding procedures for metallic materials Welding procedure test Part 12: Spot, seam and projection welding |
| ISO 669:2016 | Resistance welding Resistance welding equipment Mechanical and electrical requirements |
| ISO 14329:2003 | Resistance welding Destructive tests of welds Failure types and geometric measurements for resistance spot, seam and projection welds |
| ISO 15609-5:2011 | Specification and qualification of welding procedures for metallic materials Welding procedure specification Part 5: Resistance welding |
| ISO 3575:2016 | Continuous hot-dip zinc-coated and zinc-iron alloy-coated carbon steel sheet of commercial and drawing qualities |
| ISO 4950-2:1995 | High yield strength flat steel products — Part 2: Products supplied in the normalized or controlled rolled condition |
| ISO 4950-1:1995 | High yield strength flat steel products — Part 1: General requirements |
| ISO 5000:2011 | Continuous hot-dip aluminium-silicon-coated cold-reduced carbon steel sheet of commercial and drawing qualities |
| ISO 17677-1:2009 | Resistance welding Vocabulary Part 1: Spot, projection and seam welding |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.