Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Rules
5 General tolerances
6 Required machining allowances
7 Draft angles (taper)
8 General drawing indication
Annex A (informative) - Concept of the general
tolerancing
Annex B (informative) - Selection of general
tolerances
Annex C (informative) - Selection of required
machining allowances RMA
Annex D (informative) - Example of using general
tolerances
Annex E (informative) - Calculation of the nominal
dimension of the moulded condition
Annex F (informative) - Relation to the
GPS-Matrix-Model
Bibliography