15/30304399 DC : 0

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

BS EN ISO 20028-1 - PLASTICS - THERMOPLASTIC POLYESTER (TP) MOULDING AND EXTRUSION MATERIALS - PART 1: DESIGNATION SYSTEM AND BASIS FOR SPECIFICATIONS

Available format(s): Hardcopy, PDF

Superseded date: 30-04-2017

Language(s): English

Published date:

Publisher: British Standards Institution

Table of Contents - (Show below) - (Hide below)

Foreword
Introduction
1 Scope
2 Normative references
3 Designation system
4 Examples of designations
Annex A (normative) - Designation of thermoplastic
polyesters

Abstract - (Show below) - (Hide below)

BS EN ISO 20028-1.

General Product Information - (Show below) - (Hide below)

Comment Closes On
Committee	PRI/82
Document Type	Draft
ISBN
Pages
Published
Publisher	British Standards Institution
Status	Superseded
Superseded By	BS EN ISO 20028-1:2017

Standards Referencing This Book - (Show below) - (Hide below)

ISO 16396-1:2015	Plastics — Polyamide (PA) moulding and extrusion materials — Part 1: Designation system, marking of products and basis for specifications
ISO 1628-5:1998	Plastics — Determination of the viscosity of polymers in dilute solution using capillary viscometers — Part 5: Thermoplastic polyester (TP) homopolymers and copolymers
ASTM D 5927 : 2017 : REDLINE	Standard Classification System for and Basis for Specifications for Thermoplastic Polyester (TPES) Injection and Extrusion Materials Based on ISO Test Methods
ISO 1043-2:2011	Plastics — Symbols and abbreviated terms — Part 2: Fillers and reinforcing materials
ISO 1043-1:2011	Plastics — Symbols and abbreviated terms — Part 1: Basic polymers and their special characteristics

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Add To Cart

Product Format

Quantity

Buy now

Add to cart

Create account