• 16/30331025 DC : 0

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    BS EN 50134-2 - ALARM SYSTEMS - SOCIAL ALARM SYSTEMS - PART 2: TRIGGER DEVICES

    Available format(s):  Hardcopy, PDF

    Superseded date:  31-01-2018

    Language(s):  English

    Published date: 

    Publisher:  British Standards Institution

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    European foreword
    Introduction
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Requirements
    5 Test of manually activated trigger devices
    Annex A (normative) - Measurements of contact and insulation
            resistances for mechanical contact function
    Annex B (normative) - Strain relief test jig
    Annex C (normative) - Test set-up by using rf-shielded
            test fixtures
    Bibliography

    General Product Information - (Show below) - (Hide below)

    Comment Closes On
    Committee ²GW/1/12
    Document Type Draft
    Publisher British Standards Institution
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 61020-1:2009 Electromechanical switches for use in electrical and electronic equipment - Part 1: Generic specification
    EN 50134-5:2004 Alarm systems - Social alarm systems - Part 5: Interconnections and communications
    EN 50055:1998 Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group I apparatus indicating up to 5 % (v/v) methane in air
    EN 61020-1:2009 Electromechanical switches for use in electrical and electronic equipment - Part 1: Generic specification
    IEC 61779-2:1998 Electrical apparatus for the detection and measurement of flammable gases - Part 2: Performance requirements for group I apparatus indicating a volume fraction up to 5 % methane in air
    EN 50134-1:2002 Alarm systems - Social alarm systems - Part 1: System requirements
    EN 50057:1998 Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group II apparatus indicating up to 100 % lower explosive limit
    IEC 62599-1:2010 Alarm systems - Part 1: Environmental test methods
    EN 60447:2004 Basic and safety principles for man-machine interface, marking and identification - Actuating principles
    IEC 61779-4:1998 Electrical apparatus for the detection and measurement of flammable gases - Part 4: Performance requirements for group II apparatus indicating up to 100% lower explosive limit
    EN 303 131 : 1.1.0 DRAFT ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM); SHORT RANGE DEVICES; WIRELESS ALARMS WITH LOW DUTY CYCLE; HARMONIZED EN COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE R&TTE DIRECTIVE
    IEC 62599-2:2010 Alarm systems - Part 2: Electromagnetic compatibility - Immunity requirements for components of fire and security alarm systems
    IEC 61779-3:1998 Electrical apparatus for the detection and measurement of flammable gases - Part 3: Performance requirements for group I apparatus indicating a volume fraction up to 100 % methane in air
    IEC 60477:1974 Laboratory d.c. resistors
    IEC 61779-5:1998 Electrical apparatus for the detection and measurement of flammable gases - Part 5: Performance requirements for group II apparatus indicating a volume fraction up to 100 % gas
    EN 50056:1998 Electrical apparatus for the detection and measurement of combustible gases - Performance requirements for Group I apparatus indicating up to 100 % (v/v) methane in air
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective