AGMA 2003 : REV B : 1997 : R2003

Foreword
1 Scope
2 Nomenclature
3 Applicability
4 Criteria for gear tooth capacity
5 Fundamental rating formulas
6 Pinion torque
7 Overload factor, K[o] (K[A])
8 Safety factor, S[H] and S[F]
9 Service factors
10 Dynamic factor, K[v]
11 Size factors, C[s] (Z[x]), K[s] (Y[x])
12 Load distribution factor, K[m] (K[HBeta])
13 Crowning factor for pitting, C[xc] (Z[xc])
14 Lengthwise curvature factor for bending strength, K[x]
   (Y[Beta])
15 Geometry factors, I (Z[I]) and J (Y[J])
16 Stress Cycle factors, C[L] (Z[NT]) and K[L] (Y[NT])
17 Hardness ratio factor for pitting resistance, C[H] (Z[W])
18 Temperature factor, K[T] (K[0])
19 Reliability factors, C[R] (Z[Z]) and K[R] (Y[Z])
20 Elastic coefficient for pitting resistance, C[p] (Z[E])
21 Allowable Stress numbers
Annexes
A Values for overload factor, K[o] (K[A])
B Miner's Rule
C Geometry factors, I and J
C (M) Geometry factors, Z[I] and Y[J]
D Geometry factor figures
E Bevel gear sample calculations

Describes a method for rating the pitting resistance and bending strength of generated straight bevel, zerol bevel and spiral bevel gear teeth.