AGMA 6001 : REV D : 1997
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
DESIGN AND SELECTION OF COMPONENTS FOR ENCLOSED GEAR DRIVES
Hardcopy
English
01-01-2003
04-02-2020
Foreword
1 Scope
2 Definitions and symbols
3 Design conditions
4 Shafts
5 Keys
6 Bearings
7 Housings
8 Threaded fasteners
9 Miscellaneous components
Annexes
A Allowable stresses for typical key and keyway materials
B Allowable stresses for typical threaded fasteners
C Interference fit torque capacity
D Previous method - shaft design
E Sample problems - transmission shaft design
F Sample problems - deflection
G References
Describes the basic practices for the design and selection of components, other than gearing, for use in commercial and industrial enclosed gear drives.
| DevelopmentNote |
Supersedes AGMA 255.03, AGMA 260.02, AGMA 265.01 (03/2002) For the metric edition of this standard, see AGMA 6101. (01/2010)
|
| DocumentType |
Standard
|
| Pages |
48
|
| ProductNote |
Reconfirmed 1997
|
| PublisherName |
American Gear Manufacturers Association
|
| Status |
Superseded
|
| SupersededBy |
| ANSI/AGMA 6135:A2002(R2019) | Design, Rating and Application of Industrial Globoidal Wormgearing (Metric Edition)<br> |
| ANSI/AGMA 6035-A2002(R2019) | Design, Rating and Application of Industrial Globoidal Wormgearing |
| AGMA 9002 : B | BORES AND KEYWAYS FOR FLEXIBLE COUPLINGS (INCH SERIES) |
| SAE J429_201405 | Mechanical and Material Requirements for Externally Threaded Fasteners |
| AGMA 904 : C | METRIC USAGE |
| AGMA 2001 : D | FUNDAMENTAL RATING FACTORS AND CALCULATION METHODS FOR INVOLUTE SPUR AND HELICAL GEAR TEETH |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.