AS 1359.10-1989

1 - AS 1359.10-1989 ROTATING ELECTRICAL MACHINES - GENERAL REQUIREMENTS - DESIGNATIONS AND DIMENSIONS
4 - PREFACE
5 - CONTENTS
6 - 1 SCOPE.
6 - 2 APPLICATION.
6 - 3 REFERENCED DOCUMENTS.
6 - 4 DESIGNATION OF FRAMES, FLANGES, AND SHAFTS.
6 - 4.1 Frame designation
6 - 4.2 Flange designation
6 - 4.3 Shaft designation
6 - 5 DESIGNATION OF MACHINES.
6 - 5.1 Foot-mounted machine.
6 - 5.2 Flange-mounted machine.
6 - 5.3 Foot-mounted machine with flange.
6 - 6 DESIGNATION OF SLIDE RAILS.
7 - 7 FOOT-MOUNTED MACHINES.
7 - 7.1 Dimensions.
7 - 7.2 Location of terminal box and cable entry.
7 - 7.3 Parallelism of shaft axis and the base plane.
7 - 8 FLANGE-MOUNTED, FACE-FLANGE-MOUNTED AND SKIRT-MOUNTED MACHINES.
7 - 8.1 Dimensions.
7 - 8.2 Location of terminal box and cable entry.
7 - 8.3 Spigot concentricity and squareness of face of flange
7 - 9 FOOT-MOUNTED MACHINES WITH FLANGES
7 - 10 PAD-MOUNTED AND ROD-MOUNTED MACHINES
7 - 11 SHAFT EXTENSIONS.
7 - 11.1 General.
7 - 11.2 Dimensions.
10 - 11.3 Run-out.
14 - 12 SLIDE RAILS.
15 - APPENDIX A - LIST OF REFERENCED DOCUMENTS

Specifies the international (IEC 72) system of designations for machine parts (frames, mounting flanges, and shafts) and of the machines themselves, whether foot-mounted, flange-mounted, or both. Standardized dimensions are specified for machines with shaft heights from 56 mm to 400 mm, flanges from 55 mm to 1080 mm PCD, shafts of 7 mm to 150 mm diameter, and slide-rail mountings for machines with shaft heights from 80 mm to 315 mm. Appropriate flanges are specified for particular frame sizes.

This Standard specifies a system of designations and values for important dimensions of machines and slide rails.It does not specify any relationship between shaft designation and frame designation because of other factors involved, e.g. power output, speed, and duty cycle. For the allocation of flange designation to frame designation, see Clause 9.

First published as part of AS C332.1-1963.
AS C332.2 first published 1963.
AS 1017 first published 1971.
AS C332.1-1963, AS C332.2-1963 and AS 1017-1971 revised, amalgamated and redesignated AS 1360.10-1975.
Revised and redesignated in part as AS 1359.10-1985.
Second edition 1989.