AS 2338-2004

1 - AS 2338-2004 PREFERRED DIMENSIONS OF WROUGHT METAL PRODUCTS
4 - PREFACE
5 - CONTENTS
6 - 1 SCOPE
6 - 2 APPLICATION
6 - 3 SELECTION OF SIZES
6 - 4 CROSS-SECTIONAL DIMENSIONS
6 - 4.1 General
7 - 4.2 Basis of Tables 1 to 5
7 - 4.3 Tolerances
7 - 5 WIDTHS OF FLAT METAL PRODUCTS
7 - 6 LENGTHS OF FLAT METAL PRODUCTS
15 - APPENDIX A - NOTES ON PREFERRED SIZES
15 - A1 RANGE OF SIZES
15 - A2 PREFERRED NUMBERS
15 - A3 SELECTION OF SIZES
15 - A3.1 Use of preferred numbers
16 - A3.2 Use of more rounded values of preferred numbers

Specifies the preferred sizes, or dimensions, of wrought metal products manufactured from steel (hot-rolled and bright), copper, copper alloys, aluminium and aluminium alloys.

This Standard specifies preferred sizes, or dimensions, of wrought metal products manufactured from steel (hot-rolled and brightsee Note 1), copper, copper alloys, aluminium and aluminium alloys.It applies to round, square, hexagonal, and rectangular metal products conventionally known as rod, wire and bar, and to flat metal products conventionally known as plate, sheet, and strip. NOTES: 1 For the purposes of this Standard, bright steel is intended to cover cold-drawn, cold-sized, and cold-finished steel, produced by means other than wire manufacture. 2 Information on preferred sizes and their application in practice is given in Appendix A.

Originated as AS 1027-1971, AS 1123-1972, AS 1153-1972, AS 1184-1972 and AS 1256-1973.
Previous edition AS 2338-1980.
Second edition 2004.