AS B213-1966
Withdrawn
A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.
Involute splines
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
01-01-1966
21-02-2025
Specifies dimensions of involute splined shafts and holes with a 30 degrees pressure angle. Basic formulas for calculating dimensions and tolerances are included, with guidance on obtaining the fit desired. Terms used are defined. The Standard also describes methods of gauging and inspecting splines, with methods of obtaining dimensions and tolerances for gauges. Inspection of splines using pins is covered and tables of measurements over and between pins are included.
| Committee |
ME-011
|
| DocumentType |
Standard
|
| Pages |
76
|
| PublisherName |
Standards Australia
|
| Status |
Withdrawn
|
| Supersedes |
This British Standard provides data and guidance for the design of straight involute splines of 30 pressure angle, tabulates limiting dimensions and deals with manufacturing errors and their effect on the fit between mating spline elements.The range of splines covered is:Side fit, 2.5/5 to 32/64 pitch, flat root 6 to 60 splines inclusive Major diameter fit, 3/6 to 16/32 pitch, flat root 6 to 60 splines inclusive Side fit, 2.5/5 to 48/96 pitch, fillet root 6 to 60 splines inclusive (see figure 1)
| Standards | Relationship |
| BS 3550:1963 | Identical |
Obsolescent
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.