AS/NZS 3750.8:1994
Current
The latest, up-to-date edition.
Paints for steel structures Vinyl paints - Primer, high-build and gloss (Reconfirmed 2013)
Hardcopy , PDF 1 User , PDF 3 Users , PDF 5 Users , PDF 9 Users
English
05-12-1994
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Provides requirements for vinyl paints used as primers, intermediate coats and finishing coats intended for the exterior protection of iron and steel against atmospheric corrosion.
| Committee |
CH/3
|
| DocumentType |
Standard
|
| ISBN |
0 7262 9356 3
|
| Pages |
18
|
| ProductNote | |
| PublisherName |
Standards Australia
|
| Status |
Current
|
| Supersedes |
This Standard sets out requirements for vinyl paints to be used as primers, intermediate coats and finishing coats and intended for the protection of steel against exterior atmospheric corrosion. Paints specified in this Standard are those described under Paint References 7, 16 and 23 in AS 2312.Normally applied by conventional air or airless spray, vinyl primers, vinyl high-build paints and gloss finishing paints are intended for protection of steel against corrosion in damp or wet areas, coastal/marine environments and areas of high humidity or industrial fallout.The vinyl primer is usually supplied as light grey or red oxide and is intended as a base coat for vinyl finishing coats for direct application to bare steel or as a tie coat over a zinc primer.The high-build vinyl paints are available in a range of colours including micaceous iron oxide (MIO) pigmentation and are intended for use as intermediate or finishing coats where extra protection is required.The vinyl gloss paints are primarily intended as finishing coats over vinyl primer or high-build vinyl. The vinyl high-build and gloss may also be used over other primers. Although available in a range of colours, early chalking and loss of gloss is characteristic but this has no significant effect on the protective properties of the coating.NOTES:1 These paints may be used for paint systems MP3-A, MP3-B, MP3-C, MP5-C, MP5-G, MP5-L, LP1-C, LP1-G, GZLP-H, MSZLP-E described in AS 2312.2 Appendix A provides recommendations on information which should be provided by the purchaser at the time of enquiry or order.3 Additional information on the use and application of vinyl paints is given in Appendix B.4 Alternative methods for determining compliance with this Standard are contained in Appendix C.
First published as AS 3886-1991.
Jointly revised and redesignated as Joint Standard AS/NZS 3750.8:1994.
| AS 1580.401.1-1981 | Paints and related materials - Methods of test Surface dry condition |
| AS/NZS 2310:2002 | Glossary of paint and painting terms (Reconfirmed 2016) |
| AS 1580.103.1-1980 | Paints and related materials - Methods of test Preliminary examination and preparation for testing |
| AS/NZS 1580.481.1.8:1998 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of cracking (Reconfirmed 2013) |
| AS 1580.603.1-1992 | Paints and related materials - Methods of test Finish |
| AS 1580.101.5-1986 | Paints and related materials - Methods of test Conditions of test, temperature and humidity controlled |
| AS/NZS 1580.481.1.10:1998 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of flaking and peeling (Reconfirmed 2013) |
| AS 1580.481.3-2002 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of corrosion of coated metal substrates (Reconfirmed 2013) |
| AS 1580.481.1.8-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of cracking |
| AS/NZS 1580.481.1.6:1998 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of erosion (Reconfirmed 2013) |
| AS 1580.214.1-1990 | Paints and related materials - Methods of test - Consistency - Stormer viscometer |
| AS 1580.108.2-2004 | Paints and related materials - Methods of test Dry film thickness - Paint inspection gauge (Reconfirmed 2019) |
| AS 3904.1-1987 | Quality management and quality system elements Guidelines |
| AS/NZS 1580.403.1:1999 | Paints and related materials - Methods of test Scratch resistance (Reconfirmed 2013) |
| AS/NZS 1580.205.2:1997 | Paints and related materials - Methods of test Application properties - Conventional spraying (Reconfirmed 2013) |
| AS 1580.402.1-2003 | Paints and related materials - Methods of test Bend test |
| AS/NZS 1580.101.5:1999 | Paints and related materials - Methods of test Conditions of test - Temperature and humidity control (Reconfirmed 2013) |
| AS 2310-1980 | Glossary of paint and painting terms |
| AS 1580.455.1-1982 | Paints and related materials - Methods of test Resistance to water at room temperature |
| AS 1580.108.2-1993 | Paints and related materials - Methods of test Dry film thickness - Paint inspection gauge |
| AS/NZS 1580.481.1.2:1998 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Discolouration (including bronzing) (Reconfirmed 2013) |
| AS 1580.481.1.2-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Discolouration (including bronzing) |
| AS 1580.481.3-1992 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of corrosion of coated metal substrates |
| AS 1580.205.4-1981 | Paints and related materials - Methods of test Application properties - Airless spraying |
| AS 1580.301.2-1990 | Paints and related materials - Methods of test Non-volatile content by volume (volume solids) (Reconfirmed 2013) |
| AS 1580.457.1-1988 | Paints and related materials - Methods of test Resistance to natural weathering |
| AS/NZS 1580.108.1:1994 | Paints and related materials - Methods of test Determination of dry film thickness on metallic substrates - Non-destructive methods (Reconfirmed 2013) |
| AS 1580.404.1-1981 | Paints and related materials - Methods of test Recoating properties |
| AS/NZS 1580.211.2:1995 | Paints and related materials - Methods of test Ease of manual re-incorporation (Reconfirmed 2013) |
| HB 18.44-1991 | Guidelines for third-party certification and accreditation - Guide 44: General rules for ISO or IEC international third-party certification schemes for products |
| AS/NZS 1580.601.1:1995 | Paints and related materials - Methods of test Colour - Visual comparison (Reconfirmed 2013) |
| AS/NZS 1580.404.1:1997 | Paints and related materials - Methods of test Recoating properties (Reconfirmed 2013) |
| AS 1580.105.2-1993 | Paints and related materials - Methods of test Pretreatment of metal test panels - Sanding |
| AS/NZS 1580.481.1.9:1998 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of blistering (Reconfirmed 2013) |
| AS 1580.108.1-1980 | Paints and related materials - Methods of test Determination of dry film thickness on iron and steel substrates (permanent magnet instruments) |
| AS 3900.1-1987 | Quality management and quality assurance Standards Guidelines for selection and use |
| AS 1627.4-1989 | Metal finishing - Preparation and pretreatment of sufaces - Abrasive blast cleaning |
| AS 1580.211.2-1980 | Paints and related materials - Methods of test Ease of manual re-incorporation |
| AS/NZS 1580.481.1.7:1998 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of checking (Reconfirmed 2013) |
| AS 1399-1990 | Guide to AS 1199 - Sampling procedures and tables for inspection by attributes |
| AS 1580.603.1-2002 | Paints and related materials - Methods of test Finish - General appearance (Reconfirmed 2013) |
| AS 1580.602.2-1974 | Paints and related materials - Methods of test Specular gloss |
| AS/NZS 1580.104.1:2000 | Paints and related materials - Methods of test Recommended materials for test panels (Reconfirmed 2013) |
| AS 2905-1986 | Steel drums |
| AS 1580.105.2-2002 | Paints and related materials - Methods of test Pretreatment of metal test panels - Sanding |
| AS 2854-2004 | Tinplate cans for general use |
| AS/NZS 1580.101.1:1999 | Paints and related materials - Methods of test Conditions of test - Temperature, humidity and airflow control (Reconfirmed 2013) |
| AS 1580.104.1-1992 | Paints and related materials - Methods of test Recommended materials for test panels |
| AS 1580.601.1-1975 | Paints and related materials - Methods of test Colour - Visual comparison |
| AS 2674-1983 | Paints for steel structures - Epoxy primer (two-pack) |
| AS 2312-1984 | Guide to the protection of iron and steel against exterior atmospheric corrosion |
| AS/NZS 1580.455.1:1997 | Paints and related materials - Methods of test Resistance to water at room temperature (Reconfirmed 2013) |
| AS 2855-2004 | Paints and related materials - Micaceous iron oxide pigment (Reconfirmed 2016) |
| AS/NZS 1580.457.1:1996 | Paints and related materials - Methods of test Resistance to natural weathering (Reconfirmed 2013) |
| AS 1580.402.1-1992 | Paints and related materials - Methods of test Bend test |
| AS 2854-1986 | Tinplate cans for general use |
| AS 1199-1988 | Sampling procedures and tables for inspection by attributes |
| AS/NZS 1580.401.1:1999 | Paints and related materials - Methods of test Surface dry condition (Reconfirmed 2013) |
| AS 1580.403.1-1981 | Paints and related materials - Methods of test Scratch resistance |
| AS/NZS 1580.211.1:1995 | Paints and related materials - Methods of test Degree of settling (Reconfirmed 2013) |
| AS 1580.205.2-1981 | Paints and related materials - Methods of test Application properties - Conventional air spraying |
| AS 1580.481.1.10-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of flaking and peeling |
| AS 1580.101.1-1986 | Paints and related materials - Methods of test Air drying conditions |
| AS/NZS 1580.481.1.5:1999 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Change in gloss (Reconfirmed 2013) |
| AS 2855-1986 | Paints and related materials - Micaceous iron oxide pigment |
| AS/NZS 2312:2002 | Guide to the protection of structural steel against atmospheric corrosion by the use of protective coatings |
| AS 1580.408.2-2004 | Paints and related materials - Methods of test Adhesion - Knife test (Reconfirmed 2019) |
| AS 1580.408.2-1993 | Paints and related materials - Methods of test Adhesion - Knife test |
| AS/NZS 1580.214.1:1997 | Paints and related materials - Methods of test Consistency - Stormer viscometer (Reconfirmed 2013) |
| AS 1580.481.1.6-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of erosion |
| AS 1627.4-2005 | Metal finishing - Preparation and pretreatment of surfaces Abrasive blast cleaning of steel (Reconfirmed 2017) |
| AS/NZS 1580.602.2:1995 | Paints and related materials - Methods of test Measurement of specular gloss of non-metallic paint films at 20°, 60° and 85° (Reconfirmed 2013) |
| AS 2905-2005 | Steel drums |
| AS 1580.211.1-1980 | Paints and related materials - Methods of test Degree of settling |
| AS 1580.481.1.9-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of blistering |
| AS 1580.481.1.5-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Change in gloss |
| AS/NZS 1580.205.4:1998 | Paints and related materials - Methods of test Application properties - Airless spraying (Reconfirmed 2013) |
| AS/NZS 1580.103.1:1995 | Paints and related materials Methods of test - Examination and preparation of samples for testing (Reconfirmed 2013) |
| AS 1580.481.1.7-1991 | Paints and related materials - Methods of test Coatings - Exposed to weathering - Degree of checking |
| AS/NZS 5131:2016 | Structural steelwork - Fabrication and erection |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.