AS/NZS 62301(INT):2003

1 - AS/NZS 62301(Int):2003 HOUSEHOLD ELECTRICAL APPLIANCES-MEASUREMENT OF STANDBY POWER
4 - PREFACE
5 - CONTENTS
6 - FOREWORD
7 - 1 SCOPE
7 - 2 REFERENCED DOCUMENTS
7 - 3 DEFINITIONS
7 - 3.1 Standby mode
8 - 3.2 Standby power
8 - 3.3 Rated power
8 - 3.4 Rated voltage
8 - 3.5 Rated frequency
8 - 4 GENERAL CONDITIONS FOR MEASUREMENTS
8 - 4.1 General
8 - 4.2 Test room
8 - 4.3 Power supply
9 - 4.4 Supply voltage waveform
9 - 4.5 Power measurement accuracy
9 - 5 MEASUREMENTS
9 - 5.1 General
10 - 5.2 Selection and preparation of appliance or equipment
10 - 5.3 Procedure
10 - 5.3.1 Where the selected mode is stable
10 - 5.3.2 All other measurements
11 - 6 TEST REPORT
11 - 6.1 Appliance (equipment) details
11 - 6.2 Test parameters
11 - 6.3 Measured data, for each mode as applicable
11 - 6.4 Test and laboratory details
12 - APPENDIX A - SOME TYPICAL MODES FOR SELECTED APPLIANCE TYPES
12 - A1 BACKGROUND
12 - A2 SUBSIDIARY FUNCTION(S)
12 - A3 POWER SWITCH
12 - A4 OPERATING LOAD
12 - A5 APPLIANCE TYPES
15 - APPENDIX B - NOTES ON THE MEASUREMENT OF LOW POWER MODES
15 - B1 POWER MEASUREMENTS ISSUES
15 - B2 CREST FACTOR
15 - B3 INSTRUMENTS FOR POWER MEASUREMENTS
16 - B4 HARMONIC COMPONENTS OF THE CURRENT WAVEFORM
16 - B5 CYCLIC OR PULSING LOAD EFFECTS
17 - B6 ASYMMETRIC CURRENT WAVEFORMS (D.C. COMPONENTS)
18 - APPENDIX C - CONVERTING POWER VALUES TO ENERGY
18 - C1 GENERAL
20 - APPENDIX D - DETERMINATION OF UNCERTAINTY OF MEASUREMENT
21 - APPENDIX E - AS/NZS EL-015 AND IEC TC 59 PUBLICATIONS FOR MEASURING ENERGY AND PERFORMANCE OF HOUSEHOLD ELECTRICAL...

Specifies methods of measurement of electrical power consumption in standby mode. It is applicable to mains powered electrical household appliances and equipment and to the mains powered parts of appliances or equipment that use other fuels such as gas or oil.

This Interim Standard specifies methods of measurement of electrical power consumption in standby mode. It is applicable to mains powered electrical household appliances and to the mains powered parts of appliances that use other fuels such as gas or oil. This Interim Standard does not specify safety requirements. It does not specify minimum performance requirements nor does it set maximum limits on power or energy consumption. NOTES: 1 This Interim Standard may be applicable to other low power modes. 2 The measurement of energy consumption and performance of appliances during intended use are generally specified in the relevant product Standards and are not intended to be covered by this Interim Standard. 3 The term appliances in this Interim Standard means household appliances or equipment.

First published as AS/NZS 62301(Int):2003.