ASME A112.3.1 : 2007 : R2012
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
STAINLESS STEEL DRAINAGE SYSTEMS FOR SANITARY DWV, STORM, AND VACUUM APPLICATIONS, ABOVE- AND BELOW-GROUND
Hardcopy , PDF
27-08-2021
English
31-07-2018
Foreword
Committee Roster
Correspondence With the A112 Committee
1 General
2 Requirements
3 Test Methods and Performance Requirements
4 Markings
5 Floor Drain Dimensions
6 Trench Drain Dimensions
Nonmandatory Appendix
A - Handling, Inspection, and Installation Practices for
Stainless Steel Drainage and Vacuum Systems
Describes material, dimensions, mechanical, and physical (including marking) requirements for socket-type, seam-welded, stainless steel pipe, fittings, joints, and drains for use in plumbing sanitary and storm, drain, waste, and vent (DWV), and vacuum systems.
| DocumentType |
Revision
|
| Pages |
36
|
| ProductNote |
Reconfirmed 2012
|
| PublisherName |
American Society of Mechanical Engineers
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This Standard establishes material, dimensions, mechanical, and physical (including marking) requirements for socket-type, seam-welded, stainless steel pipe, fittings, joints, and drains for use in plumbing sanitary
and storm, drain, waste, and vent (DWV), and vacuum systems. It includes minimum requirements for workmanship,
dimensions, weld strength, pressure testing,
and marking that incorporates a push-fit joining methodNOTE: Material suitability for specific chemical applications
shall be determined by a qualified engineer or ascertained from
the manufacturer
| ASTM D 1149 : 2016-02 | TEST METHODS FOR RUBBER DETERIORATION - CRACKING IN AN OZONE CONTROLLED ENVIRONMENT |
| ASTM E 10 : 2017-05 | TEST METHOD FOR BRINELL HARDNESS OF METALLIC MATERIALS |
| ASME B1.20.1 : 2013(R2018) | PIPE THREADS, GENERAL PURPOSE (INCH) |
| ASTM E 527 : 2016 : REDLINE | Standard Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS) |
| ASME B16.5 : 2017 | PIPE FLANGES AND FLANGED FITTINGS: NPS 1/2 THROUGH NPS 24 METRIC/INCH STANDARD |
| ASTM E 8 : 2004 | Standard Test Methods for Tension Testing of Metallic Materials |
| ASTM D 471 : 2016-02 | TEST METHOD FOR RUBBER PROPERTY - EFFECT OF LIQUIDS |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.